Abstract:In this paper, we introduce a low-cost, expansible, and compatible measurement and control system for atomic force microscopes (AFM) based on a quartz tuning fork (QTF) self-sensing probe and frequency modulation, which is mainly composed of an embedded control system and a probe system. The embedded control system is based on a dual-core OMAPL138 microprocessor (DSP + ARM) equipped with 16 channels of a 16-bit high-precision general analog-to-digital converter (ADC) and a 16-bit high-precision general digital-to-analog converter (DAC), six channels of an analog-to-digital converter with a second-order anti-aliasing filter, four channels of a direct digital frequency synthesizer (DDS), a digital input and output (DIO) interface, and other peripherals. The uniqueness of the system hardware lies in the design of a high-precision and low-noise digital-analog hybrid lock-in amplifier (LIA), which is used to detect and track the frequency and phase of the QTF probe response signal. In terms of the system software, a software difference frequency detection method based on a digital signal processor (DSP) is implemented to detect the frequency change caused by the force gradient between the tip and the sample, and the relative error of frequency measurement is less than 3%. For the probe system, a self-sensing probe controller, including an automatic gain control (AGC) self-excitation circuit, is designed for a homemade balanced QTF self-sensing probe with a high quality factor (Q value) in an atmospheric environment. We measured the quality factor (Q value) of the balanced QTF self-sensing probes with different lengths of tungsten tips and successfully realized AFM topography imaging with a tungsten-tip QTF probe 3 mm in length. The results show that the QTF-based self-sensing probe and the developed AFM measurement and control system can obtain high quality surface topography scanning images in an atmospheric environment.

A new device built to measure the mechanical characters of the double ended tuning Fork

A New Type of MEMS Accelerometer with Up-Tuning Structure

Double Tuning-Fork Resonant Accelerometer

A micromachined resonant accelerometer

An New Instrument for Measuring Mechanical Compliance of Micro-Systems

Design, fabrication, and characterization of a high-sensitivity integrated quartz vibrating beam accelerometer

Design and implementation of a fully-decoupled tuning fork (FDTF) MEMS vibratory gyroscope for robustness improvement

Research On The Sensing Performance Of The Tuning Fork-Probe As A Micro Interaction Sensor

Fabrication and testing of a novel silicon probe for micromachined surface profilers.

An All-Quartz Integrated Resonant Accelerometer With High Sensitivity and Stability: Design, Fabrication, and Measurement

High Accuracy Resonant Pressure Sensor With Balanced-Mass DETF Resonator and Twinborn Diaphragms

Resonant Frequency Tunable Silicon Fishbone-Shaped MEMS Double Ended Tuning Fork.

Comparison of Two Resonant Structures in Silicon Oscillating Accelerometers

Design and fabrication of a novel silicon probe for micromachined surface profilers

Sensitivity Manipulation on Micro-Machined Resonant Electrometer Toward High Resolution and Large Dynamic Range

Design and Characterization of a T-shaped Two-Axis Force Sensor

A Biaxial Resonant Tilt Sensor with Two-Stage Microleverage Mechanisms

Novel Instrument for Characterizing Comprehensive Physical Properties under Multi-Mechanical Loads and Multi-Physical Field Coupling Conditions.

A Mems Accelerometer Based On Synchronizing Detf Oscillators

Sensing Performance Analysis on Quartz Tuning Fork-Probe at the High Order Vibration Mode for Multi-Frequency Scanning Probe Microscopy.

Measurement and Control System for Atomic Force Microscope Based on Quartz Tuning Fork Self-Induction Probe