Abstract:As the core component and only isolation component of energy routing equipment, medium voltage high-frequency transformers need to achieve a high insulation level under high power density. Aim for this requirement, the multi-layer shielding structure with shielding structures inside and outside the main wall insulation layer is adapted to the medium voltage high-frequency transformer to achieve the bundling and softening of electrical stress. However, the introduction of shielding structures may cause significant changes in the parasitic parameters of medium-voltage high-frequency transformers, especially in the parasitic capacitor network. The change of parasitic capacitance not only affects the power transmission characteristics of transformers but also changes the electromagnetic coupling path of the system and introduces new electromagnetic interference circuits. Therefore, in this digest, with distributed parameter modeling, an equivalent circuit model for the medium voltage high-frequency transformer with a multi-layer shielding structure is proposed. A five-capacitor network is used for the description of the electrical coupling for the multi-layer shielding structure. The obtaining method of the parameters is proposed in detail. The accuracy of the proposed equivalent circuit is fully verified with the broadband impedance spectrum

Determination of Transformer Shielding Foil Structure for Suppressing Common-Mode Noise in Flyback Converters

Design of the Number of Transformer Shielding Winding Turns for Minimizing Low-Frequency Common-Mode Noise in Flyback Converters

Design of Transformer Shielding Foil Structure for Minimizing Common-Mode Noise in LLC Resonant Converters

Determination of the Width of Shielding Foil in Sandwiched Winding Transformer for Minimizing Common Mode EMI of Flyback Converters

Transformer balancing winding technology with effective shielding for suppressing common mode noise in flyback converters

Modeling And Characterization Of Incomplete Shielding Effect Of Gnd On Common-Mode Emi Of A Power Converter

Evaluation Method of Flyback Converter Behaviors on Common-Mode Noise

Suppressing Methods of Common-Mode Noise in LLC Resonant DC-DC Converters

Analysis and Suppression of Common-Mode EMI Noise in 1 MHz 380 V-12 V DCX Converter with Low NFoM Devices

Non-Ideal Electric Field Shielding With Grounding Resistor For Suppressing Emi Coupling In A Power Converter

A Symmetrical Resonant Converter and PCB Transformer Structure for Common Mode Noise Reduction

An Optimization Method for Planar Transformer Winding Losses in GaN Based Multi-output Flyback Converter

Suppressing Method of Common-Mode Noise in MHz 380V-12V DCX Converter

Design and Analysis of Single-Stage Power Factor Correction Converter with a Feedback Winding

Modeling and Suppression of Conducted Interference in Flyback Power Supplies Based on GaN Devices

Characterizing Noise Source and Coupling Path in Flyback Converter for Common-Mode Noise Prediction

Transformer Structure of Bifilar Primary Winding with Advanced Common Mode Noise Attenuation Performance for Isolated DC-DC Converters

Broadband Equivalent Circuit Modeling for Medium Voltage High-Frequency Transformers with Multi-Shielding Structure

Modeling and Predicting for Common Mode Noise Disturbance in Flyback Converter

An Improved Winding Loss Analytical Model of Flyback Transformer

A Systematic Design and Optimization Technique for the Suppression of EMI Common Mode (CM) Noise