Abstract:In this study, we examined the effect of calcination temperature on the structural, electrical transport and optical characteristics of Cd 0.3 Ni 0.2 Co 0.3 Cu 0.2 Fe 2 O 4 spinel ferrites. The samples, designated as S850 and S950, were prepared using sol-gel method, followed by calcination at 850 °C and 950 °C, respectively. The structural analysis for the samples S850 and S950 reveals its crystallization in the cubic spinel structure ( ). Subsequently, as the temperature of calcination increased there was an increasing trend observed in both the unit cell parameters and average crystallite size. In addition, we studied the optical properties of the samples. Using Tauc" s reflectance method, the optical band gap energy values ( E g ) were estimated. These analyses confirmed the direct optical transitions of the samples. Furthermore, the direct band-gap energies for S850 and S950 were found as E gd = 1.875 eV and E gd = 1.746 eV, respectively. Then, the calculated low Urbach energies ( E u = 1.05 eV for S850 and E u = 1.01 eV for S950) revealed the high quality of our samples. This observation implies that increasing the calcination temperature reduces the level of disorder and defects. The study also investigated the changes in optical constants, like the extinction coefficient and penetration depth, as a function of wavelength. The refractive index changes were used to determine the Cauchy parameters, while the Wemple-Didomenico equation was utilized to estimate the energy parameters related to dispersion. The research also focused on analyzing the optical dielectric and optical conductivity constants. Increased calcination temperature also decreases band-gap energy ( E g ) and activation energy ( E a ). Equivalent circuit modeling of Nyquist plots indicates that both grain and grain boundary contributions influence the conduction mechanism in the specimens. The Overlapping-Large Polaron Tunneling (OLPT) model was employed to elucidate the conduction mechanism observed in the specimens. Moreover, when subjected to high frequencies, the synthesized materials demonstrate reduced dielectric constants and minimal dielectric losses. Additionally, they exhibit heightened electrical resistivity under these conditions. These features make the Cd 0.3 Ni 0.2 Co 0.3 Cu 0.2 Fe 2 O 4 materials a potential choice for applications that require absorption of microwaves and high-frequency signals.

Sol-gel construction of honeycomb-like CuMn2O4 spinels with high infrared emissivity

Quasi-metallic High-Entropy Spinel Oxides for Full-Spectrum Solar Energy Harvesting

The Effect of Microstructure on the Middle and Short Waveband Emissivity of CuO-doped CuxCo1-xFe2O4 Spinel

New spinel‐structured high‐entropy oxides with high‐ and stable‐infrared radiation properties

Extracting optical parameters of Cu-Mn-Fe spinel oxide nanoparticles for optimizing air-stable, high-efficiency solar selective coatings

Design of morphology-controlled cobalt-based spinel oxides for efficient X-band microwave absorption

Improving the optical properties of magnesium spinel chromites through Ni and Cu substitutions for optoelectronic applications

Low-temperature synthesis of MgxCo1-xCo2O4 spinel catalysts for N2O decomposition

Spinel Cu-Mn-Cr Oxide Nanoparticle-Pigmented Solar Selective Coatings Maintaining >94% Efficiency at 750 degrees C

Spherical Fe 3 O 4 morphology modulation for enhancing infrared emissivity and radiant heat dissipation

Synthesis, Electronic Structure, and Electrochemical Properties of the Cubic Mg2MnO4 Spinel with Porous-Spongy Structure

Template-free Synthesis of Stable Cobalt Manganese Spinel Hollow Nanostructured Catalysts for Highly Water-Resistant CO Oxidation

A Novel Optimization Model and Application of Optimal Formula Design for CuxCo1−xFe2O4 Spinel-Based Coating Slurry in Relation to Near and Middle Infrared Radiation Strengthening

Enhanced near- and mid-infrared radiation property of MgCr2O4 by doping with Cu ions

Crystal phase-dependent optical properties of CoMn-based spinel oxides for solar thermal conversion

Physical properties of Cd0.3Ni0.2Co0.3Cu0.2Fe2O4 spinel ferrites under different calcination temperatures

Preparation of infrared high radiation coatings from modified spinel NiFe2O4 and its energy saving applications

Zn2SnO4 and Zn2TiO4 inverse spinels: influence of the temperature on structural, microstructural and luminescent properties

Properties of CuMn1.5Ni0.5O4 spinel as high-performance cathode for solid oxide fuel cells

Low-temperature Griffiths phase in chemically synthesized CoMn2O4 spinel oxide

Modulation of solid solution in MgxMn1−xAl2xFe2(1−x)O4 spinel ceramics for multifunctional devices