Abstract:Metalworking is an essential process for the manufacture of machinery and equipment components. The design of the die geometry is an essential aspect of metalworking, and directly affects the resultant product’s quality and cost. As a matter of fact, a comprehensive understanding of the die bearing geometry plays a vital role in the die design process. For the specific case of wire drawing, however, few efforts have been dedicated to the study of the geometry of the bearing zone. In this regard, the present paper involves an attempt to investigate the effects of different geometries of the die bearing. For different forms of reduction as well as bearing zones, measurements are carried out for the wire-drawing process. Subsequently, by extracting the friction coefficients from the electrolytic tough pitch copper wire in cold-drawn essays, the numerical simulations are also implemented. We present the results on both the superficial and center radial tensions obtained by finite element methods. It is observed that the reduction of the friction coefficient leads to an increase in radial stress, while for a given friction coefficient, the substitution of the C-type die by the R-type one results in a decrease in the superficial radial stress of up to 93.27%, but an increase at the center of the material. Moreover, the die angle is found to play a less significant role in the resultant center radial stress, but it significantly affects the superficial radial stress. Lastly, R-type dies result in smaller superficial radial stress, with a change of up to 34.48%, but a slightly larger center radial stress up to 6.55% for different die angles. The implications of the present findings are discussed.

Wire Drawing Behaviors with Die Angle and Strain Hardening Rate of a Metal

Effects of Contact Conditions at Wire–Die Interface on Temperature Distribution during Wire Drawing

Significantly Enhanced Strength of a Drawn Twinning-Induced Plasticity Steel Wire and its Deformation Twinning Dependency

Comparison of Temperature Distribution between TWIP and Plain Carbon Steels during Wire Drawing

Residual Stress Engineering for Wire Drawing of Austenitic Stainless Steel X5CrNi18-10 by Variation in Die Geometries—Effect of Drawing Speed and Process Temperature

Hardening and Softening Behavior of Caliber-Rolled Wire

Effect of Plastic Deformation on Thermal Properties in Twinning-Induced Plasticity Steel

Investigation of the Mechanics of Wire Drawing

Experimental Analysis of Wire Drawing Influence on Microstructure, Texture, and Mechanical Properties of High‐Carbon Steel for Prestressing Strand

Influences of Different Die Bearing Geometries on the Wire-Drawing Process

Effect of Microstructure and Microtexture on the Mechanical Properties of Small-Strain Cold-Drawn Pearlite Steel Wires

Copper Wire Multi-Pass Drawing: Process Modeling and Optimization

The Influence of Temperature in the Wire Drawing Process on the Wear of Drawing Dies

Hierarchical Structures in Cold-Drawn Pearlitic Steel Wire

Relating Residual Stress and Microstructure to Mechanical and Giant Magneto-Impedance Properties in Cold-Drawn Co-based Amorphous Microwires

Damage Prediction in the Wire Drawing Process

Effect of Process Parameters in Copper-Wire Drawing

Optimization of wet drawing according to the ratio of breaking stress to draw stress

Characterization of the Microstructure in Drawn Pearlitic Steel Wires

Influence of Tempering on Macro- and Micro-Residual Stresses and Yield Stress of Ferritic-Pearlitic Drawn, Coiled, and Straightened Wires

EFFECT OF HEAVILY DRAWING ON THE MICROSTRUCTURE AND PROPERTIES OF Cu-Cr ALLOYS