Abstract:Summary form only given. Capillary discharge plasmas have been widely used as electrothermal chemical (ETC) launch devices, fusion reactor pellet injectors and high heat flux sources for material studies. In the electro thermal chemical launcher, the mechanisms of the plasma-propellant interaction are critical, with many factors being of potential importance. In particular, the role of plasma radiation is disputed. We will report the effect of three different metal ions and radiation in the capillary discharge plasma on the plasma-propellant interactions. Conventionally, a capillary initiated by a metal wire of about 2 mg and with an ablative liner material (e.g. polyethylene) is used as the plasma generator. The plasma is mainly composed of CO, H + , C, etc. The proportion of metal ions was negligible. We have designed a new capillary discharge plasma generator with different metal powders of higher weight as the initiators. The performance of the new generator is compared with the traditional one through an open-air test. A spectrometer and ICCD were used to measure the surface temperature of the propellants while a CCD was used to visualize the plasma jet. The combustion tests were conducted in a transparent closed vessel, making it possible to measure the plasma parameters at the propellant surface and observe the combustion process in the closed vessel. A fused silica window was placed between the plasma and propellants to ensure that the propellant could only be affected by plasma radiation. The burning rate and the p-t curve were obtained in the tests and the combustion products were analyzed by a mass spectrometer. Interrupted burning tests were also carried out to acquire information about the surface of the propellants at different burning stages. In order to perform accurate modeling of the plasma-propellant interaction, we have also developed a two-dimensional time-dependent capillary discharge model based on a modified ablation model. In our model, special attention is paid to the radial distribution of the capillary discharge plasma characteristics. To investigate the factors that influence the radial distribution, the radial transport of the ablation products is taken into consideration. Further, the competition between the ablation and deposition process with time in the capillary discharge is also studied. The aim of our study are to provide results that will assist the design of new propellants and new plasma generators for the ETC launcher.

An Experimental Investigation on the Radiation Characteristics of Plasma Jet in the Plasma-Propellant Interaction

Study on the Characteristics of Different Plasma Ignition Schemes

Experimental Research on Electron Density in Solid-Rocket Motor Plume

Study on the Interactions between Plasma Jet and the Propellants

Roles of Metal Ions and Plasma Radiation in the Interactions Between A Capillary Discharge Plasma and Propellants

Study of the Enhanced Burning Rate During the Plasma-Propellant Interaction Process

Interaction Features of Different Propellants under Plasma Impingement

Modeling of the propellant ignition Process under plasma jet impingement

An Electrothermal Plasma Model Considering Polyethylene and Copper Ablation Based on Ignition Experiment

Research on the Dynamic Model of Plasma Ignition Process of Solid Propellant

A model for plasma ignition of solid propellant

Study of the Pitting Effects During the Pre-Ignition Plasma–propellant Interaction Process

Energy Skin Effect of Propellant Particles in Electrothermal-Chemical Launcher

Mechanism of Plasma Ignition in Electrothermal-Chemical Launcher

Experimental Study on Plasma Ignited Single-base Propellant Using SEM and EDS

Numerical Simulation of Microwave Plasma Thruster Flow IEPC-2007-211

Review of Simulation Model for Capillary Discharge Plasma and Its Interactions with Propellants

Calculation of Plasma Radiation in Electrothermal-Chemical Launcher

Numerical simulation of plasma plume and its radiative characteristic

Experimental Investigation on Flow Characteristics and Ignition Performance of Plasma-Actuated Flame Holder

Experimental investigation of the ignition and combustion characteristics of electrically controlled solid propellant