Abstract:Given the outstanding mechanical performance of lattice metamaterials, novel structural forms and performance modulation strategies have garnered considerable attention. Herein, we develop a twined tetrahedral lattice structure (TTL) with a bending defect inside the unit cell. Mechanical properties before and after the introduction of defects in TTLs were studied using experiments and numerical simulations. The developed structure exhibits strictly stretching-dominated properties in the absence of bending defects. Whereas, the bending-dominant component of TTLs is elevated with increasing bending angle that can increase energy absorption efficiency. Moreover, the relative elastic modulus and initial peak stress can be reduced by even more than 70 % and 50 %, respectively, as the bending angle increases. Besides, a theoretical model for the relative elastic modulus of TTL at θ = 0° was established based on the displacement method on the Representative Volume Element (RVE), including both Euler-Bernoulli beam theory and Timoshenko beam theory. However, the two solutions show consistent results for strictly stretching-dominated structures. The accuracy of solutions is verified by experiments and simulations. The plateau stress theoretical model for TTLs was derived from the deformation process of the RVE based on plastic hinge theory. The theoretical solutions under different θ align well with numerical and experimental results. Overall, TTLs have superior relative elastic modulus, relative yield strength, and specific energy absorption compared to common lattice structures. The developed TTLs provide a new perspective on the property regulation of mechanical metamaterials.

Two-dimensional mechanical metamaterials with bending-induced expansion behavior

2D Mechanical Metamaterials with Widely Tunable Unusual Modes of Thermal Expansion

An Inertant Elastic Metamaterial Plate with Extra Wide Low-Frequency Flexural Band Gaps

Research on low-expansion metamaterial technique of four-leaf clover bionic structure

Origami-based metamaterial with switchable abnormal expansion function

Design and characterization of novel bi-directional auxetic cubic and cylindrical metamaterials

A new design concept of dual-constituent sandwich panel with in-plane zero thermal expansion

A series of auxetic metamaterials with negative thermal expansion based on L -shaped microstructures

Size effect anomalies in the behaviour of loaded 3D mechanical metamaterials

Lattice metamaterials with controllable mechanical properties inspired by projection of four-dimensional hypercubes

2D metamaterial with in-plane positive and negative thermal expansion and thermal shearing based on interconnected alternating bimaterials

Origami Metamaterials for Tunable Thermal Expansion

Enhanced Thermal Expansion by Micro-Displacement Amplifying Mechanical Metamaterial

Multifunctional mechanical metamaterials with tunable double-negative isotropic properties

Experimental Verification of the Bending of Electromagnetic Waves Using Metamaterials

Tunable Auxetic Mechanical Metamaterials with “Arch-Shaped” Units

Elastic mechanics solution of thermal expansion of bi-material curved beam and its application to negative thermal expansion metamaterials

Micro-Structured Two-Component 3D Metamaterials with Negative Thermal-Expansion Coefficient from Positive Constituents

Correction to "Isotropic Negative Thermal Expansion Metamaterials".

Mechanical properties and regulatory strategy of twinned tetrahedral lattice structures

Soft mechanical metamaterials with unusual swelling behavior and tunable stress-strain curves