Abstract:The effect of plasma activation of reactive gas on the process of reactive magnetron synthesis of oxide coatings was theoretically and experimentally investigated using a radio-frequency inductively coupled plasma source, which creates a flow of activated reactive gas directed towards the surface on which the oxide coating is deposited. The reactive gas passes through a dense inductively coupled plasma located inside the plasma source, while argon is supplied through a separate channel near the magnetron. A theoretical model has been built allowing the calculation of spatial distributions of fluxes of metal atoms and molecules of activated reaction gas, as well as the stoichiometry area of the synthesized coatings. Calculations were performed on the example of aluminum oxide. It was found that the plasma activation of the reactive gas allows to increase the sticking coefficient of oxygen to the surface of the growing coating from values less than 0.1 for non-activated molecular oxygen to 0.9 when 500 W of RF power is introduced into the inductive discharge. In order to verify the developed model, experiments were conducted on depositing an aluminum oxide film on glass substrates located at different distances from the magnetron target, followed by measuring the distribution of film transparency along the substrate length and comparing it with the calculated distribution. A comparison of the calculation results with the experimental data shows a good agreement in the entire studied range of parameters. Based on the generalization of the obtained results, an empirical rule was formulated that the power ratio of the magnetron discharge and the plasma activator should be approximately 8:1.

Increased ultraviolet reflectivity of magnetron deposited Al films

Optical and Wetting Properties of CuAlO2 Films Prepared by Radio Frequency Magnetron Sputtering

Magnetic Anisotropy and High Frequency Permeability of Multilayered Nanocomposite FeAlO Thin Films

Optical properties of magnetron-sputtered and rolled aluminum

Uniform High-Reflectivity Silver Film Deposited by Planar Magnetron Sputtering

Synthesis of Al Thin Films with High Optical Transmittance by DC Magnetron Sputtering Process Parameter Optimization

Magnetron sputtering technique for analyzing the influence of RF sputtering power on microstructural surface morphology of aluminum thin films deposited on SiO2/Si substrates

Preparation of Alumina Thin Films by Reactive Modulated Pulsed Power Magnetron Sputtering with Millisecond Pulses

Investigation on Solar Absorption and Thermal Emittance of Al Films Deposited by Magnetron Sputtering

Microstructures Diagram Of Magnetron Sputtered Aln Deposits : Amorphous And Nanostructured Films

Effect of Aluminum by Magnetron Sputtering on the Micro-Arc Oxide Film Layer of Titanium Alloy

Optical properties of aluminum silver alloy films deposited by magnetron sputtering

Antireflection coatings for deep ultraviolet optics deposited by magnetron sputtering from Al targets.

Influence of the method of gas supply to the chamber on the processes of reactive magnetron sputtering of Ti-Al composite target

Effects of deposition temperature on the mechanical and structural properties of amorphous Al-Si-O thin films prepared by RF magnetron sputtering

The Effect of Plasma Activation of Reactive Gas in Reactive Magnetron Sputtering

Effect of film thickness on surface morphology and optical properties of nanostructured Zinc Aluminum Oxide thin films deposited by DC magnetron sputtering

Control of Roughness in Mo/Al Multilayer Film Fabricated by DC Magnetron Sputtering

Characterization of MgO/Al2O3 Composite Film Prepared by DC Magnetron Sputtering and Its Secondary Electron Emission Properties

Micrographs and Optical Properties of Al-Doped Zno Thin Films Deposited by Radio Frequency Magnetron Sputtering

Microstructure And Corrosion Resistance Of Aluminized Coatings On Magnesium Alloy By Pulsed Bias Magnetron Sputtering