Abstract:With the increase in power consumption in compact electronic devices, passive heat transfer cooling technologies with high-heat-flux characteristics are highly desired in microelectronic industries. Carbon nanotube (CNT) clusters have high thermal conductivity, nanopore size, and large porosity and can be used as wick structure in a heat pipe heatspreader to provide high capillary force for high-heat-flux thermal management. This paper reports investigations of high-heat-flux cooling of the CNT biwick structure, associated with the development of a reliable thermometer and high performance heater. The thermometer/heater is a 100-nm-thick and 600 μm wide Z-shaped platinum wire resistor, fabricated on a thermally oxidized silicon substrate of a CNT sample to heat a 2×2 mm2 wick area. As a heater, it provides a direct heating effect without a thermal interface and is capable of high-temperature operation over 800°C. As a thermometer, reliable temperature measurement is achieved by calibrating the resistance variation versus temperature after the annealing process is applied. The thermally oxidized layer on the silicon substrate is around 1-μm-thick and pinhole-free, which ensures the platinum thermometer/heater from the severe CNT growth environments without any electrical leakage. For high-heat-flux cooling, the CNT biwick structure is composed of 250 μm tall and 100 μm wide stripelike CNT clusters with 50 μm stripe-spacers. Using 1×1 cm2 CNT biwick samples, experiments are completed in both open and saturated environments. Experimental results demonstrate 600 W/cm2 heat transfer capacity and good thermal and mass transport characteristics in the nanolevel porous media.

Load Characteristics of a Suspended Carbon Nanotube Film Heater and the Fabrication of a Fast-Response Thermochromic Display Prototype.

Fabrication of Three-dimensional Thermally Conductive Carbon Fibers/Carbon Nanotubes Network Reinforce Epoxy Composites

Fast High‐Temperature Response of Carbon Nanotube Film and Its Application As an Incandescent Display

A Display Module Implemented by the Fast High-Temperatue Response of Carbon Nanotube Thin Yarns

Carbon-Nanotube-Film Microheater On A Polyethylene Terephthalate Substrate And Its Application In Thermochromic Displays

Experimental design and testing of the electrothermal properties of carbon nanotube film

Cesium tungsten oxide–carbon nanotube–hydroxypropyl cellulose thermoresponsive display

Carbon nanotube-based flexible electrothermal film heaters with a high heating rate

Rapid Thermochromic and Highly Thermally Conductive Nanocomposite Based on Silicone Rubber for Temperature Visualization Thermal Management in Electronic Devices

Carbon nanotube–cesium tungsten oxide–poly(N-isopropylacrylamide) hydrogel-based optical writing display

Flexible thermochromic fabrics enabling dynamic colored display

Carbon nanotube/polyurethane core–sheath nanocomposite fibers for wearable strain sensors and electro-thermochromic textiles

High-Quality Conductive Network Films Constructed from Carbon Nanotube/Carbon Nanofiber Composites via Electrospinning for Electrothermal Applications

An Investigation of the Design Potential of Thermochromic Home Textiles Used with Electric Heating Techniques

Design and Test of Carbon Nanotube Biwick Structure for High-Heat-Flux Phase Change Heat Transfer

Multi-scale GO/CNT/AlN nanocomposites for high-performance flexible electrothermal film heaters

Dry-transferred Single-Walled Carbon Nanotube Thin Films for Flexible and Transparent Heaters

An Electrically and Thermally Erasable Liquid Crystal Film Containing NIR Absorbent Carbon Nanotube

Heterogeneous Thermochromic Hydrogel Film Based on Photonic Nanochains

Fiber-shaped dynamic thermal radiation-regulated device based on carbon fiber and polyaniline

Direct screen printing of single-faced conductive cotton fabrics for strain sensing, electrical heating and color changing