Abstract:To get an optimized pulsed electrical plasma discharge reactor and to increase the energy utilization efficiency in the removal of pollutants, two hybrid plasma discharge reactors were designed and optimized. The reactors were compared via the discharge characteristics, energy transfer efficiency, the yields of the active species and the energy utilization in dye wastewater degradation. The results showed that under the same AC input power, the characteristics of the discharge waveform of the point-to-plate reactor were better. Under the same AC input power, the two reactors both had almost the same peak voltage of 22 kV. The peak current of the point-to-plate reactor was 146 A, while that of the wire-to-cylinder reactor was only 48.8 A. The peak powers of the point-to-plate reactor and the wire-to-cylinder reactor were 1.38 MW and 1.01 MW, respectively. The energy per pulse of the point-to-plate reactor was 0.2221 J, which was about 29.4% higher than that of the wire-to-cylinder reactor (0.1716 J). To remove 50% Acid Orange 7 (AO7), the energy utilizations of the point-to-plate reactor and the wire-to-cylinder reactor were 1.02 × 10−9 mol/L and 0.61 × 10−9 mol/L, respectively. In the point-to-plate reactor, the concentration of hydrogen peroxide in pure water was 3.6 mmol/L after 40 min of discharge, which was higher than that of the wire-to-cylinder reactor (2.5 mmol/L). The concentration of liquid phase ozone in the point-to-plate reactor (5.7 × 10−2 mmol/L) was about 26.7% higher than that in the wire-to-cylinder reactor (4.5 × 10−2 mmol/L). The analysis results of the variance showed that the type of reactor and reaction time had significant impacts on the yields of the hydrogen peroxide and ozone. The main degradation intermediates of AO7 identified by gas chromatography and mass spectrometry (GCMS) were acetic acid, maleic anhydride, p-benzoquinone, phenol, benzoic acid, phthalic anhydride, coumarin and 2-naphthol. Proposed degradation pathways were elucidated in light of the analyzed degradation products.

Optimizing the electrical excitation of an atmospheric pressure plasma advanced oxidation process.

Degradation of Nitenpyram Pesticide in Aqueous Solution by Low-Temperature Plasma

Optimizing Energy Efficiency for Industrial Application of Pulsed Corona Gas Cleaning Techniques

Degradation of Acid Orange 7 Dye in Two Hybrid Plasma Discharge Reactors

Optimization for Plasma-facilitated Catalytic Reduction of NO_x

Insights into mixed dye pollutant degradation by oxygen and air plasma bubbling array

Effective utilization of ozone in plasma-based advanced oxidation process

Atmospheric Pressure Plasma Jet in Organic Solution: Spectra, Degradation Effects of Solution Flow Rate and Initial pH Value

Degradation of Organic Wastewater by Pulsed Discharge Plasma

Degradation of Acid Orange 7 in an Atmospheric-Pressure Plasma-Solution System (gliding Discharge)

Visualization of In Situ Oxidation Process Between Plasma and Liquid Phase in Two Dielectric Barrier Discharge Plasma Reactors Using Planar Laser Induced Fluorescence Technique

Enhanced Degradation of Organic Wastewater Containing P-Nitrophenol by A Novel Wet Electrocatalytic Oxidation Process: Parameter Optimization and Degradation Mechanism

Degradation Mechanism of Organic Pollutant in Water by Plasma

Degradation of Micropollutants in Water by O Atoms Produced by an Atmospheric Pressure He/O2 Plasma Jet

Effect of gas components on the post-discharge temporal behavior of OH and O of a non-equilibrium atmospheric pressure plasma driven by nanosecond voltage pulses

Kinetics and Operational Parameters for 1,4-Dioxane Degradation by the Photoelectro-Peroxone Process

Research on different oxidants synergy with dielectric barrier discharge plasma in degradation of Orange G: Efficiency and mechanism

Effect of dielectric barrier discharge plasma on persulfate activation for rapid degradation of atrazine: Optimization, mechanism and energy consumption

Oxidation of Airborne m-Xylene in Pulsed Corona Discharge: Impact of Water Sprinkling

Process optimization of nanosecond pulsed packed‐bed discharge plasma for SF6 degradation based on response surface methodology

Reducing energy consumption in plasma NO conversion utilizing plasma aerodynamic effect