Abstract:In this paper, we proposed a general direct design method for three-dimensional freeform surfaces and freeform imaging systems based on a construction-iteration process. In the preliminary surfaces-construction process, the coordinates as well as the surface normals of the data points on the multiple freeform surfaces can be calculated directly considering the rays of multiple fields and different pupil coordinates. Then, an iterative process is employed to significantly improve the image quality or achieve a better mapping relationship of the light rays. Three iteration types which are normal iteration, negative feedback and successive approximation are given. The proposed construction-iteration method is applied in the design of an easy aligned, low F-number off-axis three-mirror system. The primary and tertiary mirrors can be fabricated on a single substrate and form a single element in the final system. The secondary mirror is simply a plane mirror. With this configuration, the alignment difficulty of a freeform system can be greatly reduced. After the preliminary surfaces-construction stage, the freeform surfaces in the optical system can be generated directly from an initial planar system. Then, with the iterative process, the average RMS spot diameter decreased by 75.4% compared with the system before iterations, and the maximum absolute distortion decreased by 94.2%. After further optimization with optical design software, good image quality which is closed to diffraction-limited is achieved. (C) 2015 Optical Society of America

Design Method of Surface Contour for A Freeform Lens with Wide Linear Field-Of-View

Formulating the Design of Two Freeform Lens Surfaces for Point-Like Light Sources.

Design of Athermalized Wide-Angle Low-Distortion Lens Using Freeform Surface

Design Of Freeform Lenses For Illuminating Hard-To-Reach Areas Through A Light-Guiding System

Design of Off-Axis Reflective Projection Lens Using Spherical Fresnel Surface

Design of freeform imaging systems with linear field-of-view using a construction and iteration process.

Designing Two Freeform Surfaces with Monge–Ampère Equation Method for Point-Like Sources

Freeform Surface Lens Design for Uniform Illumination

Construction Method Through Forward and Reverse Ray Tracing for A Design of Ultra-Wide Linear Field-Of-View Off-Axis Freeform Imaging Systems

Method to Design Two Aspheric Surfaces for a Wide Field of View Imaging System with Low Distortion

Freeform lens for off-axis illumination in optical lithography system

Distortion correction for imaging on non-planar surface using freeform lens

Multiple surface expansion method for design of freeform imaging systems.

Design Method of Freeform Off-Axis Reflective Imaging Systems with a Direct Construction Process.

67.2: Distortion Correction Using a Freeform Lens for Projection onto a Non‐planar Surface

Freeform Lens Arrays For Off-Axis Illumination In An Optical Lithography System

Starting Configuration Design Method of Freeform Imaging and Afocal Systems with A Real Exit Pupil

Direct design of freeform surfaces and freeform imaging systems with a point-by-point three-dimensional construction-iteration method.

Free-form Lens Design for Wide-Angle Imaging with an Equidistance Projection Scheme

Design Method for Freeform Off-Axis Three-Mirror Anastigmat Optical Systems with a Large Field of View and Low Error Sensitivity

Design method of freeform off-axis three-mirror reflective imaging systems