Abstract:This work presents the application of the methodology for the sensitization of surface acoustic wave-based sensors (SAW), developed in the first part of this work. The strategy of the method is the obtention of sensing layers with tailored chemical environments by taking advantage of the wide variety of chemical composition of the organic polymers, which have been used as sensing polymers, and combining them with polyurethane (PU) to form polymeric composites that show enhanced properties as sensing materials for the SAW sensor technology. In the first part of this work, the ultrasonic and adhesion characterization was correlated to the sensor responses of PU-polybutylmethacrylate (PBMA) composites of different relative concentrations of the sensing polymer (PBMA) and PU. The resulting coating layers obtained with the PU polymer composites improved the chemical and mechanical properties of the sensing layer without interfering with the quality of their sensor responses in comparison to those with the pristine polymer as the sensing material. In this second part of this work, three new polyurethane polymeric composites were analyzed. The new sensing materials were produced using polylaurylmetacrylate (PLMA), polyisobutene (PIB), and poly(chlorotrifluoroethylene-co-vinylidene fluoride) (PCTFE) as the sensing polymers combined with PU. The results of the new PU polymer composites showed consequently different properties depending on the type of sensing polymer used, reproducing, however, the previous features achieved with PU and polybutylmetacrylate (PBMA) composites, like the improvements in the adhesion and the resistance against an organic solvent and preserving, in each case, the sensor response characteristic of each sensing polymer used, as was also observed for the PU-PBMA polymeric composites. The results obtained with the new sensing materials validated the strategy and confirmed its generalization as a very suitable methodology for the sensitization of SAW sensors, strongly indicating the applicability and reliability of the method, which makes possible the choice of virtually any chemical environments for the sensitization of SAW sensor systems.

Analysis of Responsive Polymer Films Using Surface Acoustic Waves

Surface Wave Transducer for Ultrasonic Nondestructive Testing of Polymer Components

Applications and Outlooks of Quartz Crystal Microbalance in Studies of Polymer Thin Films

LOCALIZED MICROSTRUCTURES FABRICATION THROUGH STANDING SURFACE ACOUSTIC WAVE AND USER-DEFINED WAVEGUIDES

Standing Surface Acoustic Wave-Assisted Fabrication of Region-Selective Microstructures Via User-Defined Waveguides.

Acoustofluidic Waveguides for Fabrication of Localized Polymeric Microstructure Arrays

Use of Torsional Acoustic Resonators for Microweighing, Polymer Rheology, and Monitoring of Biofilm Formation

Flexible Surface Acoustic Wave Device with Aln Film on Polymer Substrate

Quantitative Investigation of Layer-by-Layer Deposition and Dissolution Kinetics by New Label-Free Analytics Based on Low-Q-Whispering Gallery Modes

Acoustic Characterization of Polydimethylsiloxane for Microscale Acoustofluidics

Tunable patterning of microscale particles using a surface acoustic wave device with slanted-finger interdigital transducers

A Two-Electrode Electrochemical Surface Plasmon Resonance Sensor for Investigating the Electropolymerization of Polyaniline

Surface Acoustic Wave (SAW) Resonators for Monitoring Conditioning Film Formation

Optimization of parameters of a couple generator-receiver for a gravitational Hertz experiment

Quartz Crystal Microbalance Study of the Kinetics of Surface Initiated Polymerization

Soft Three-Dimensional Microscale Vibratory Platforms for Characterization of Nano-Thin Polymer Films

In Situ Probing of the Surface Hydration of Zwitterionic Polymer Brushes: Structural and Environmental Effects

Flexible and Transparent Surface Acoustic Wave Microsensors and Microfluidics

Package-less liquid phase sensing using surface acoustic waves on lithium tantalate oxide

Piezoelectric Layered Structure with Conductive Polymer Composites as a Waveguide Layer: Swelling Monitoring Based on the Propagation of Love-Type Wave