Abstract:The elastic properties of 1D nanostructures such as nanowires are often measured experimentally through actuation of the nanowire at its resonance frequency, and then relating the resonance frequency to the elastic stiffness using elementary beam theory. In the present work, we utilize large scale molecular dynamics simulations to report a novel beat phenomenon in [110] oriented Ag nanowires. The beat phenomenon is found to arise from the asymmetry of the lattice spacing in the orthogonal elementary directions of the [110] nanowire,i.e., [-110] and [001] directions, which results in two different principal moments of inertia. Because of this, actuations imposed along any other direction are found to decompose into two orthogonal vibrational components based on the actuation angle relative to these two elementary directions, with this phenomenon being generalizable to <110> FCC nanowires of different materials (Cu, Au, Ni, Pd and Pt).The beat phenomenon is explained using a discrete moment of inertia model based on the hard sphere assumption, the model is utilized to show that surface effects enhance the beat phenomenon, while the effect is reduced with increasing nanowires cross-sectional size or aspect ratio.Most importantly, due to the existence of the beat phenomena, we demonstrate that in resonance experiments only a single frequency component is expected to be observed, particularly when the damping ratio is relatively large or very small.Furthermore, for a large range of actuation angles, the lower frequency is more likely to be detected than the higher one,which implies the experimental predictions of Young's modulus obtained from resonance may in fact be under predictions. The present study therefore has significant implications for experimental interpretations of Young's modulus as obtained via resonance testing.

Shear Modulus Property Characterization of Nanorods

General Existence of Flexural Mode Doublets in Nanowires Targeting Vectorial Sensing Applications

The Experiment and Simulation Method to Calibrate the Shear Modulus of Individual ZnO Nanorod.

Beat Phenomena in Metal Nanowires, and Their Implications for Resonance-Based Elastic Property Measurements.

Elastic Property of Vertically Aligned Nanowires

Young׳s modulus of individual ZnO nanowires

Mechanical/Electrical Characterization of ZnO Nanomaterial Based on AFM/Nanomanipulator Embedded in SEM

Electrical Anisotropy Properties of Zno Nanorods Analyzed by Conductive Atomic Force Microscopy

Mechanical Properties Of Individual Zno Nanowire Tested Via Nanoprobe System

A New Characterization Approach to Study the Mechanical Behavior of Silicon Nanowires

Automated Electrical Measurements of Single ZnO Nanowire with Cu and Au Electrodes Under Axial Strain

Ultrafast Laser-Excited Vibration and Elastic Modulus of Individual Gold Nanorods

Extensional Vibration and Size-Dependent Mechanical Properties of Single-Crystal Gold Nanorods

Imaging the mechanical properties of nanowire arrays

Elastic Modulus Measurements on Large Diameter Nanowires Using a Nano-Assembled Platform

Force-Deflection Spectroscopy: A New Method to Determine the Young'S Modulus of Nanofilaments

Resonant Frequency-Based Method for Measuring the Young’s Moduli of Nanowires

In Situ Characterization of the Local Work Function along Individual Free Standing Nanowire by Electrostatic Deflection

Molecular Dynamics Simulation of the Tensile Mechanical Behaviors of Axial Torsional Copper Nanorod

Novel Mechanical Behavior of Zno Nanorods

Shear-induced alignment of low-aspect-ratio nanorods for modulations of multiple optical properties