Abstract:Solid-phase microextraction (SPME) has been widely used in analysis of trace organic contaminants in environmental samples. Stable, efficient, and selective fiber coating is the key to the development of SPME technique. In this study, an in situ fabricated porous carbon coating that derived from metal-organic frameworks (MOFs) was introduced for solid-phase microextraction (SPME). The carbon coating (denoted as MOF-74-C) was prepared by the direct carbonization of a MOF-74 coating that was in situ grown on stainless steel wire, which was explored for the extraction of odorous organic contaminants for the first time. MOF-74-C coated fiber showed high extraction efficiency (1.1–16.0 times larger than commercial fibers for most tested analytes under the same extraction conditions), as well as good thermal and chemical stability. Furthermore, it can selectively extract the analytes with the simultaneous exclusion of coexisting dissolved organic matter due to the molecular sieve effect invoked by the well-defined micropores. The method based on MOF-74-C coating for analysis of odorants afforded wide linear ranges (more than two orders of magnitude), low detection limits (below the odor threshold concentrations), good intra- and inter-day accuracies (90.1–107.3%) and precisions (relative standard deviations/RSDs below 9.4%) and satisfactory reproducibility (RSDs below 8.7%). Finally, the MOF-74-C coated fiber was successfully applied for the SPME analysis of odorants in real water samples. These results highlight the great potential of in situ fabricated porous carbons derived from MOFs for SPME applications.

[The Study of Carbonaceous Adsorbent for Solid-Phase Microextraction and the Comparison with Commercial Device].

Preparation and Characteristics of New Coating for Solid-Phase Microextraction.

DETECTION OF ORGANIC SUBSTANCES IN WATER BY SOLID-PHASE MICRO-EXTRACTION WITH ACTIVE CARBON COATED EXTRACTOR

Application of Ceramic/carbon Composite As a Novel Coating for Solid-Phase Microextraction.

Comparisons of SPME and traditional GC preparation technology

Preparation and Investigation of Solid Phase Microextraction Complex Coating of Phenylethylenethyl Acrylate Copolymer and Polymethylsiloxane

Analysis of five pesticide residues in water samples by using laboratory-made solid-phase microextraction device

Meso-/microporous Carbon As an Adsorbent for Enhanced Performance in Solid-Phase Microextraction of Chlorobenzenes

Investigation of a Novel Activated Carbon Coating Fiber Used for Solid Phase Micro-Extraction

Preparation and Characterization of Porous Carbon Material-Coated Solid-Phase Microextraction Metal Fibers.

In-situ Kinetic and Thermodynamic Study of 2,4-Dichlorophenoxyacetic Acid Adsorption on Molecularly Imprinted Polymer Based Solid-Phase Microextraction Coatings

Study on a Novel Circulating Cooling Solid-Phase Microextraction Method.

Analysis of organochlorine pesticides in water by novel activated carbon fiber-solid phase microextraction coupled with gas chromatography-mass spectrometry.

Applications of carbon-based materials in solid phase micro-extraction: a review

[Developments in Preparation and Experimental Method of Solid Phase Microextraction Fibers].

On-Fiber Standardization Technique for Solid-Coated Solid-Phase Microextraction

A solid-phase microextraction fiber with carbon nanoparticles as sorbent material prepared by a simple flame-based preparation process

Solid-Phase Microextraction in the Pretreatment of Environmental Samples

Application of solid phase micro-extraction method on analysis of volatile organic compounds in air

Research Progress of Solid Phase Microextraction and Application in Pesticide Residue Analysis

In Situ fabricated porous carbon coating derived from metal-organic frameworks for highly selective solid-phase microextraction