Abstract:We proposed a novel sensor based on an ultracompact leaky-guided liquid core fiber Mach–Zehnder interferometer (LLCFMZI) for high modulation of an interference spectrum. The sensor structure is based on a micro-sized hollow-core fiber (HCF) splicing a tilt end face single-mode fiber (SMF) to create a miniature oblique gap for the effective access of different liquids. The liquid core with a relatively lower refractive index (RI) than the cladding can achieve a leaky-mode optical waveguide (LMOW) mechanism, and its volume is only approximately 7.85 pL. In addition, the utilized micro-length HCF can reduce the energy loss of core in the LMOW to obtain an acceptable extinction ratio (>30 dB) with high temperature (T) sensitivity in the interference spectra. Experimental results show that the interference spectra can be highly modulated within the wide measurement range of 1250–1650 nm with a steadily linear response for thermal effect. The measured temperature sensitivities (T-sensitivities) of various liquids of DI water, ethanol, and Cargille-liquid (nD = 1.305) are 0.8869, 4.4754, and 4.8229 nm/°C, and the corresponding measured thermal optics coefficient (TOC) are −4.16 × 10−5, −2.11 × 10−4, and −3.6 × 10−4 °C−1, respectively. Measurement results demonstrate that the used liquids with a higher TOC can obtain better T-sensitivity modulation. The highest experimental sensitivity of the liquid-core filled with Cargille-liquid (nD = 1.40) is up to +13.87 nm/°C with a corresponding TOC of −4.07 × 10−4 °C−1. Furthermore, the experimental and theoretical values are in good agreement according to FSR the measuring scheme that investigates the effectiveness of the proposed LLCFMZI.

An Integrated Tunable Interferometer Controlled by Liquid Diffusion in Polydimethylsiloxane

Tunable Fabry-Perot Interferometer from Ferroelectric Polymer Based on Surface Energy Modification

In Situ Fabrication of a Tunable Microlens.

Bioinspired solid–liquid mixed tunable lens with multilayered structure

Flexible fluidic lens with polymer membrane and multi-flow structure

Integrative Optofluidic Microcavity with Tubular Channels and Coupled Waveguides Via Two-Photon Polymerization

A thin-core fiber modal interferometer for liquid-level sensing

Design and Fabrication of Multimode Interference Coupler with Strong Confinement Structure on Silicon-On-Insulator

3D Printing Optofluidic Mach-Zehnder Interferometer on a Fiber Tip for Refractive Index Sensing

Liquid-crystal Based Fabry-Perot Interferometer Displacement Sensor

Four-wave Mixing-Based Photonic Crystal Fiber Microfluid Sensor with Embedded U-shape Microslits

Tunable Microfluidic Optical Devices with an Integrated Microlens Array

Tunable Meta-Fluidic-Materials Base on Multilayered Microfluidic System

Microfluidic Refractive Index Sensor Based on an All-Silica In-Line Fabry-Perot Interferometer Fabricated with Microstructured Fibers.

Recent Development of Tunable Optical Devices Based on Liquid

Refractive Index Detection by Using an Integrated Microfluidic Device

Design of Liquid Lens Based Optical System for Microfluidic Chip Detection

Ultrasensitive Optofluidic Interferometer for Online Monitoring of Photocatalytic Reactions

Design and Experimental Demonstration of a Compact Silicon Photonic Interleaver Based on an Interfering Loop with Wide Spectral Range

Highly Modulated In-Fiber Mach–Zehnder Interferometer Based on an Ultracompact Leaky-Guided Liquid Core

A Compact Optofluidic Cytometer with Integrated Liquid-Core/pdms-cladding Waveguides.