Abstract:A lattice temperature model is derived for oxide-confined vertical cavity surface emitting lasers (VCSELs) based on carrier transport and the conservation of energy. Peltier heat is caused by the bandedge and quasi-Fermi level discontinuities at a heterojunction. However, considering the device size, Peltier heat needs to be distributed and is not just generated at the interface, otherwise, an anomolous spike in temperature will occur. We have developed a novel treatment to model the Peltier heat at a heterojunction by use of a Monte Carlo simulation. Peltier heat is found to be a major heat contributor, and it results in a rapid and high temperature rise in the separate confinement heterostructure (SCH) region of the laser diode. We have also shown that the carrier thermal conductivities for materials with high mobilities must be included at high carrier densities because they contribute to additional spreading of the thermal energy. Subsequently, this lattice temperature model is coupled self-consistently to electronic and optical solvers to form a complete simulator for VCSELs. Self-heating causes a fast temperature rise when the VCSEL is operated under continuous wave conditions, causing resonant wavelength changes and an eventual thermal rollover. The resonant wavelength shift has been shown to be caused mainly by the heating of the distributed Bragg reflectors even though the peak temperature occurs within the SCH region. Possible physical factors causing the thermal rollover have also been examined with our complete simulator. The Auger recombination process is found to be one of the main factors causing the thermal rollover in 980 nm oxide-confined VCSELs while the photon lifetime is a factor in determining the position of the thermal rollover. We have also achieved a very good match between our simulated results and experimental data.

An ellipse model for cavity mode behavior of optically injection-locked VCSELs.

Effects of the Spatial Nonuniformity of Optical Transverse Modes on the Modulation Response of Vertical-Cavity Surface-Emitting Lasers

The Electrical Turn-on Characteristics of Vertical-Cavity Surface-Emitting Lasers

Resonant-wavelength Control and Optical-Confinement Analysis for Graded SCH VCSELs Using a Self-Consistent Effective-Index Method

Theoretical Modelling of Single-Mode Lasing in Microcavity Lasers Via Optical Interference Injection.

Numerical Investigation of Self-Heating Effects of Oxide-Confined Vertical-Cavity Surface-Emitting Lasers

Lattice Temperature Model and Temperature Effects in Oxide-Confined VCSEL’s

Analysis of microcavity VCSEL lasing modes using a full-vector weighted index method

Experimental Study on the Dynamics of Polarized Strong Optical Injection in 1550 Nm Vcsels

Experimental and Theoretical Study of Wide Hysteresis Cycles in 1550 Nm VCSELs under Optical Injection.

A Simple Model for Cavity Enhanced Slow Lights in Vertical Cavity Surface Emission Lasers

Equivalent circuit modeling of the dynamic operation of ultra-high speed multi-mode VCSELs

The Impact of Oxide Layer Placement and Thickness on the Optical Properties of Oxide-Confined VCSEL

Simulating the Spiking Response of VCSEL-based Optical Spiking Neuron

An Electrooptothermal-Coupled Circuit-Level Model for VCSELs under Pulsed Condition

Oscillation characteristics of electrically-pumped vertical external cavity surface emitting lasers

Long-wavelength vertical-cavity surface-emitting lasers

1080Nm Optically Pumped Vertical-External-cavity Surface-Emitting Laser

Modeling full PCSELs and VCSELs using modified rigorous coupled-wave analysis

Estimate of mode coupling in a spin-VECSEL

Single-Mode Vertical Cavity Surface Emitting Laser via High-Order Transverse Mode Expansion