Abstract:The continuous development and application of laser technology, and the increasing energy and power of laser output have promoted the development of various types of laser optical systems. The optical components based on quartz materials are key components of high-power laser systems, and their quality directly affects the load capacity of the system. Due to the photothermal effect when the laser interacts with the quartz material and generates extremely high temperatures in a short period of time, it is impossible to experimentally solve the phenomena and physical mechanisms under extreme conditions. Therefore, it is very important to select a suitable method to investigate the thermal effect of intense laser interaction with quartz materials and explain the related physical mechanism. In this study, a three-dimensional quarter-symmetric laser heating quartz material geometry model by using nonlinear transient finite element method was established, and its transient temperature field distribution of the quartz material after being heated by a 1,064 nm continuous laser was investigated. In addition, the influence of different laser parameters (laser spot radius, heat flux and irradiation time), material parameters (material thickness, material absorption rate of laser) on the thermal effect of heating quartz material were also studied. When the laser heat flux is 20 W/cm2, the diameter of the laser spot is 10 cm, the irradiation time is 600 s and the thickness is 4 cm, the temperature after laser heating can reach 940.18°C, which is far lower than the melting point. In addition, the temperature maximum probes were set at the overall model, spot edge and rear surface respectively, and their temperature rise curves with time were obtained. It is also found that there is a significant hysteresis period for the rear surface temperature change of the quartz material compared with the overall temperature change due to heat conduction. Finally, the method proposed can also be applied to the laser heating of other non-transparent materials.

Numerical Investigation of Self-Heating Effects of Oxide-Confined Vertical-Cavity Surface-Emitting Lasers

Lattice Temperature Model and Temperature Effects in Oxide-Confined VCSEL’s

Effects of the Spatial Nonuniformity of Optical Transverse Modes on the Modulation Response of Vertical-Cavity Surface-Emitting Lasers

Theoretical Analysis of Thermal-Lensing Effect in a High Power Exciplex Pumped Cs Vapor Laser.

The Electrical Turn-on Characteristics of Vertical-Cavity Surface-Emitting Lasers

Modeling of Kinetic and Thermodynamic Processes in a Flowing Exciplex Pumped Alkali Vapor Laser

Modeling of Steady-State Temperature Distribution in Diode-Pumped Alkali Vapor Lasers: Analysis of the Experimental Results

Thermal Design Considerations for III-N Vertical-Cavity Surface-Emitting Lasers Using Electro-Opto-Thermal Numerical Simulations

Resonant-wavelength Control and Optical-Confinement Analysis for Graded SCH VCSELs Using a Self-Consistent Effective-Index Method

Theoretical Modelling of Single-Mode Lasing in Microcavity Lasers Via Optical Interference Injection.

Thermal Effects in High-Power Double Diode-End-Pumped Cs Vapor Lasers

Thermally Induced Current Bifurcation and Drastically Collapse of Output Optical Power in VCSEL Arrays

The Impact of Oxide Layer Placement and Thickness on the Optical Properties of Oxide-Confined VCSEL

850nm Vertical Cavity Surface Emitting Lasers Utilizing The Self-Planar Mesa Structure

Simulation Of Thermal Tuning In V-Coupled Cavity Laser With An On-Chip Thin-Film Heater

Simulation study on the thermal effect of continuous laser heating quartz materials

A Thermal Analysis of the Operation of Microscale, Inorganic Light-Emitting Diodes

Equivalent circuit modeling of the dynamic operation of ultra-high speed multi-mode VCSELs

Finite Element Simulation of the Optical Modes of Semiconductor Lasers

Analysis of microcavity VCSEL lasing modes using a full-vector weighted index method

Improved performances of 850 nm vertical cavity surface emitting lasers utilizing the self-planar mesa structure