Abstract:In the present study, we analyse the mechanical structure for the two-stage anvil cell, and design the two-stage high pressure cell using diamond-cemented carbide compound as anvil-material. The diamond-cemented carbide compound material is synthesized using the 6 × 2500 ton cubic press in our laboratory. We sinter diamond/Co layer (Φ30 mm×10 mm) on a WC-cobalt substrate (Φ30 mm×13 mm) at high pressures and temperatures, then, we obtain the cubic anvils from the sintered cylindrical chunks by wire-electrode cutting. The diamond-cemented carbide compound anvil has three advantages over the traditional sintered diamond anvil:first, a scaled-up version of the sintered diamond anvil could be obtained by sintering the diamond/Co layer on a WC-cobalt substrate;second, the diamond-cemented carbide compound anvil is machined easily compared with the sintered diamond anvil;and third, the experimental cost using the diamond-cemented carbide compound anvils is much lower than using the sintered diamond anvil. Using the diamond-cemented carbide compound anvil, we design the two-stage 5.5/1.5 (octahedral edge-length/anvil truncation edge-length, in millimetre) assemble. Pressure calibration at room temperature is performed for the 5.5/1.5 assemble using the phase transitions of Zr (α-ω, 7.96 GPa;ω-β, 34.5 GPa) under high pressures. The pressure range of the two-stage apparatus besed on hinge-type cubic press is extended from 20 GPa to about 35 GPa using the 5.5/1.5 assemble. The pressure calibration for the two-stage apparatus using diamond-cemented carbide compound anvil is ongoing in our laboratory. We believe that the pressures above 50 GPa could be achieved using these anvils.

In situ impedance measurements in diamond anvil cell under high pressure.

Calibration of Pressure to 35 Gpa for the Cubic Press Using the Diamond-Cemented Carbide Compound Anvil

In situ measurement techniques using diamond anvil cell at high pressure–temperature conditions: A review

Study of Diamond Anvil Cell for In-Situ High-temperature and High-pressure Spectrum

Probing local pressure environment in anvil cells with nitrogen vacancy (NV-) centers in diamond

The Gem Anvil Cell: High-Pressure Behaviour of Diamond and Related Materials

A Diamond Gasket for the Laser-Heated Diamond Anvil Cell

An exploration of surface enhanced Raman spectroscopy (SERS) for in situ detection of sulfite under high pressure

Application of a New Composite Cubic-Boron Nitride Gasket Assembly for High Pressure Inelastic X-Ray Scattering Studies of Carbon Related Materials.

Improved techniques for measurement of superconductivity in diamond anvil cells by magnetic susceptibility

Raman Spectra Based Pressure Calibration of the Non-Gauge Sapphire Anvil Cell at High Temperature and High Pressure

New Condensed Matter Probes for Diamond Anvil Cell Technology

In situ surface enhanced Raman spectroscopy detection in high pressure solution

Composite Chemical Vapor Deposition Diamond Anvils for High-Pressure/high-temperature Experiments

Preparation of W-Ta thin-film thermocouple on diamond anvil cell for in-situ temperature measurement under high pressure

In Situ Measurements of Electrical Resistivity of Metals in a Cubic Multi-Anvil Apparatus by Van Der Pauw Method

Second pathway for completion of human DNA base excision‐repair: reconstitution with purified proteins and requirement for DNase IV (FEN1)

Diamond Anvil Cell Behavior Up to 4 Mbar

Electrical Resistivity Measurements of Conductors in the Diamond-Window, High-Pressure Cell

An Introduction to the Experimental Technology of Diamond-Anvil Cell

Recent Design of Ultrahigh-Pressure Diamond Cell