Synergetic effect of oleophilic textured surfaces and MoS 2 on the tribological properties of Ti-6Al-4V alloy under dry and lubricated sliding conditions
Turali Narayana,Shahid Saleem,Narayana Turali,Sheikh Shahid Saleem
DOI: https://doi.org/10.1088/2051-672x/ad237e
2024-01-31
Surface Topography Metrology and Properties
Abstract:In the present work, surface modification of Ti-6Al-4V alloy was carried out using Laser surface texturing (LST). The investigation aims to explore the synergetic impact of LST and molybdenum disulfide (MoS2), as a solid lubricant, on the tribological properties of Ti-6Al-4V alloy. Three types of LST textures (Circular, triangular, and square textures) were created on the Ti6Al4V alloy. Subsequently, tribological tests were conducted on a universal tribometer (ball-on-disc), at a load of 20 N with a frequency of 15 Hz. The worn surface was analyzed using various methods, including optical microscopy, 3D-profilometer, FESEM, EDAX analysis, and Raman spectroscopy. The study compared the coefficient of friction (COF) and wear behavior of un-textured surfaces (U TS ) with those of textured surfaces (T S ) under both dry sliding conditions (D SC ) and lubricated sliding conditions (L SC ). The results demonstrated a significant reduction in the COF and wear coefficients on the T S . Specifically, the circular texture exhibited significant results with a 10.30%, 10.42%, and 28.80% decrease in COF and a remarkable reduction of 39.22%, 47.51%, and 77.90% in wear coefficients compared to the U TS tested under D SC and L SC (using PAO-4 and PAO-4 + 1% wt MoS 2 ). Severe abrasion, adhesion, and delamination as the primary wear mechanisms were observed on the U TS and T S under D SC , while the L SC was characterized by mild adhesive and delamination wear on the U TS and T S . The carbon layer formation and concentration of Mo and S particles resulted in lower friction and wear coefficients for the U TS , and T S under LSC (PAO-4 + 1% wt MoS 2 ). The analysis indicated that the use of LST and solid lubricant nanoparticles on a Ti-6Al-4V alloy would result in improved service life and better endurance in cutting tools and tribo-mating parts.
materials science, multidisciplinary,engineering, mechanical,instruments & instrumentation