Abstract:For three-phase AC-DC power conversion, the widely-used continuous current mode (CCM) modulation scheme results in relatively high semiconductor losses from hard-switching each device during half of the mains cycle. Triangular current mode (TCM) modulation, where the inductor current reverses polarity before turn-off, achieves zero-voltage-switching (ZVS) but at the expense of a wide switching frequency variation (15x for the three-phase design considered here), complicating filter design and compliance with EMI regulations. In this paper, we propose a new modulation scheme, sinusoidal triangular current mode (S-TCM), that achieves soft-switching, keeps the maximum switching frequency below the 150 kHz EMI regulatory band, and limits the switching frequency variation to only 3x . Under S-TCM, three specific modulation schemes are analyzed, and a loss-optimized weighting of the current bands across load is identified. The 2.2 kW S-TCM phase-leg hardware demonstrator achieves 99.7% semiconductor efficiency, with the semiconductor losses accurately analytically estimated within 10% (0.3 W). Relative to a CCM design, the required filter inductance is 6x lower, the inductor volume is 37% smaller, and the semiconductor losses are 55% smaller for a simultaneous improvement in power density and efficiency.

An Advanced Spread-Spectrum Clock Generator with Triangular Modulation for Emi Suppressing

A Programmable Spread Spectrum Clock Generation

A novel spread-spectrum clock generator for suppressing conducted EMI in switching power supply

A Spread Spectrum Clock Generator with a Wide Frequency and Attenuation Tuning Range Based on a Third-Order Error-Feedback Delta-Sigma Modulator

A Novel Multiphase Clock Generator Based on Digital DLL Designed for Oversampling in Transceiver

An Advanced Monolithic Digitalized Random Carrier Frequency Spread-Spectrum Clock Generator for Emi Suppression

A Spread-Spectrum Clock Generator with FIR-embedded Binary Phase Detection and 1-Bit High-Order ΔΣ Modulation.

A 2.4 mW 2.5 GHz multi-phase clock generator with duty cycle imbalance correction in 0.13 µm CMOS

A 5ghz 200khz/5000ppm Spread-Spectrum Clock Generator with Calibration-Free Two-Point Modulation Using a Nested-Loop BBPLL

A 92 Fsrms Jitter Frequency Synthesizer Based on a Multicore Class-C Voltage-Controlled Oscillator with Digital Automatic Amplitude Control

2.5 Mw 2.73 GHz Non-Overlapping Multi-Phase Clock Generator with Duty-Cycle Correction in 0.13 Μm CMOS

Novel ZVS S-TCM Modulation of Three-Phase AC/DC Converters

Research on periodic switching frequency modulation for conducted EMI suppressing in power converter

An Advanced Spread Spectrum Architecture Using Pseudorandom Modulation to Improve EMI in Class D Amplifier

Optimization of Frequency Jittering Parameters for Conducted EMI Suppression in Switching Mode Power Supplies

A True Single-Phase Clock Dual-Modulus Prescaler with Enhanced Robustness Against Leakage Currents

A 7.5GHz 3.4mA triple-modulus prescaler based on novel phase-switching technique

Design of Ternary Clock Generator

A Novel Low-Power and High-Speed Dual-Modulus Prescaler Based on Extended True Single-Phase Clock Logic.

A 0.5-V, 0.05-to-3.2ghz LC-Based Clock Generator for Substituting Ring Oscillators under Low-Voltage Condition

Design of a Multi-mode Clock Generator with a PLL