Abstract:In the CBM (Compressed Baryonic Matter) experiment constructed at the Facility for Anti-proton and Ion Research (Fair) at GSI, Darmstadt, Germany, MRPC(Multi-gap Resistive Plate Chamber) is adopted to construct the large TOF (Time-of-Flight) system to achieve an unprecedented precision of hadron identification, benefiting from its good time resolution, relatively high efficiency and low building price. We have developed a kind of double-ended readout strip MRPC. It uses low resistive glass to keep good performance of time resolution under high-rate condition. The differential double stack structure of 2x4 gas gaps help to reduce the required high voltage to half. There are 24 strips on one counter, and each is 270mm long, 7mm wide and the interval is 3mm. Ground is placed onto the MRPC electrode and feed through is carefully designed to match the 100 Ohm impedance of PADI electronics. The prototype of this strip MRPC has been tested with cosmic ray, a 98% efficiency and 60ps time resolution is gotten. In order to further examine the performance of the detector working under higher particle flux rate, the prototype has been tested in the 2014 October GSI beam time and 2015 February CERN beam time. In both beam times a relatively high rate of 1 kHz/cm2 was obtained. The calibration is done with CBM ROOT. A couple of corrections has been considered in the calibration and analysis process (including time-walk correction, gain correction, strip alignment correction and velocity correction) to access actual counter performances such as efficiency and time resolution. An efficiency of 97% and time resolution of 48ps are obtained. All these results show that the real-size prototype is fully capable of the requirement of the CBM-TOF, and new designs such as self-sealing are modified into the strip counter prototype to obtain even better performance.

Beam Test Results of Two Kinds of High-Rate Multi-Gap Resistive Plate Chambers

Beam Test Results of High Counting Rate MRPCs at GSI

Development of Multi-Gap Resistive Plate Chambers with Low-Resistive Silicate Glass Electrodes for Operation at High Particle Fluxes and Large Transported Charges

Performance Testing of a Long-Strip Two-End Readout Multi-Gap Resistive Plate Chamber

A Prototype of a High Rating MRPC

Study on the Performance of High Rating Mrpc

Development of High-Rate Mrpcs for High Resolution Time-Of-Flight Systems

Performance studies of MRPC prototypes for CBM

Study on the Performance of Multi-Gap Resistive Plate Chambers

Measurements of the Rate Capability of Various Resistive Plate Chambers

Aging Test of a Real-Size High Rate MRPC for CBM-TOF Wall

Performance Study of a Real-Size Mosaic High-Rate MRPC

A Prototype of Strip Readout MRPC for CBM-TOF

Development of Multi-gap Resistive Plate Chamber (MRPC) for medical imaging

Methods for the Manufacture and Test of Multi-Gap Resistive Plate Chambers

The High-Rate Sealed MRPC to Promote Pollutant Exchange in Gas Gaps: Status on the Development and Observations

Research On Cosmic Ray Mass Test Method Of Mrpc

Development and test of a real-size MRPC for CBM-TOF

Measurement of the Rate Capability of Resistive Plate Chambers

Design and Test of a Gluing High Rate MRPC

Study of High Time Resolution MRPC with the Waveform Digitizer System