Bipolar Ripple Cancellation Method to Achieve Single-Stage Electrolytic-Capacitor-Less High-Power LED Driver

Yajie Qiu,Laili Wang,Hongliang Wang,Yan-Fei Liu,Paresh C. Sen

DOI: https://doi.org/10.1109/jestpe.2015.2433918

IF: 5.462

2015-01-01

IEEE Journal of Emerging and Selected Topics in Power Electronics

Abstract:Conventional topologies for high-power LED drivers with high power factors (PFs) require large capacitances to limit the low frequency (100 or 120 Hz) LED current ripples. Electrolytic capacitors are commonly used because they are the only capacitors with sufficient energy density to accommodate high-power applications. However, the short life span of electrolytic capacitors significantly reduces the life span of the entire LED lighting fixture, which is undesirable. This paper proposes a bipolar (ac) ripple cancellation method with two different full-bridge power structures to cancel the low-frequency ac ripple in the LED current and minimize the output capacitance requirement, enabling the use of long-life film capacitors. Compared with the existing technologies, the proposed circuit achieves zero double-line-frequency current ripple through LED lamps and achieves a high PF and high efficiency. A 100-W (150 V/0.7 A) LED driver prototype was built which demonstrates that the proposed method can achieve the same double-line-frequency LED current ripple with only 44-mu F film capacitors, compared with the 4700-mu F electrolytic capacitors required in the conventional single-stage LED drivers. Meanwhile, the proposed prototype has achieved a peak power efficiency of 92.5%, benefiting from active clamp technology.