Abstract:The strategic initiative aimed at building “digital metallurgy” implies the introduction of diagnostic monitoring systems to trace the technical condition of critical production units. This problem is relevant for rolling mills, which provide the output and determine the quality of products of metallurgical companies. Making up monitoring systems requires the development of digital shadows and coordinate observers, the direct measurement of which is either impossible or associated with numerous difficulties. These coordinates include the spindle torque applied by the spring-transmitting torque from the motor to the rolling stand rolls. The development and research are conducted by the example of the electromechanical systems of the horizontal stand at the plate mill 5000. The stand electric drive characteristics are given, and the emergency modes that cause mechanical equipment breakdowns are analyzed that. The relevance of analyzing transient torque processes in emergency modes has been accentuated. The paper points to the shortcomings of the system for elastic torque direct measurement, including low durability due to the harsh operating conditions of precision sensors. It also highlights the need to install the measuring equipment after each spindle. The disadvantage of the previously developed observer is the function of calculating the electric drive speed derivative. This causes a decrease in noise immunity and signal recovery accuracy. The contribution of this paper is building a digital elastic torque observer that has advantages over conventional technical solutions, based on the theoretical and experimental studies. The technique for virtual observer adjustment was developed and tested in the Matlab-Simulink software package. For the first time, a comprehensive analysis was conducted for spindle elastic torques in emergency modes that caused equipment damage. An algorithm was developed for an emergency shutdown of a stand electric drive in the worst-case mode of strip retraction between work and backup rolls, due to the overlap of the strip on the roll. Further, the algorithm was tested experimentally. The criteria for diagnosing pre-emergencies was then justified. An adaptive motor-braking rate controller was developed. The developed observer and emergency braking system are in operation at the mill 5000. Long experimental research proved the efficiency of dynamic load monitoring and the reduction in the number of equipment breakdowns.

Online Monitoring System Design for Roll Eccentricity in Rolling Mills

Dynamic Multimode Process Monitoring Using Recursive GMM and KPCA in a Hot Rolling Mill Process

On-line monitoring of oxidation states in HSS work rolls during hot rolling using pulsed eddy current testing

Development and Practical Implementation of Digital Observer for Elastic Torque of Rolling Mill Electromechanical System

Elongation Control of the Ultra-Thin Tinplate During Two-Stand Temper Rolling Unsteady Process

Adaptive Pass Scheduling for Roughness Control in Cold Rolling

Development of electrical runout online measurement system based on eddy current technique and laser triangulation

Quality-Related Monitoring and Control in Hot Strip Mill Process

Immersion and invariance adaptive decentralized control for the speed and tension system of the reversible cold strip rolling mill

The accuracy of rolling thickness adjustment in conditions of high-frequency disturbances taking into account the speed of roll setting devices

Research on nonlinear dynamic vertical vibration characteristics and control of roll system in cold rolling mill

Prediction and analysis of cold rolling mill vibration based on a data-driven method

Nash equilibrium-based distributed predictive control strategy for thickness and tension control on tandem cold rolling system

Vibration monitoring and analysis of strip rolling mill based on the digital twin model

Coupled Vertical–Horizontal Vibration Characteristics of a Cold Rolling Mill Based on an Optimized Karman Differential Equation

Integrated AGC Approach for Balancing the Thickness Dynamic Response and Shape Condition of a Hot Strip Rolling Control System

Research on Dynamic Response of Cold Rolling Mill with Dynamic Stiffness Compensation

Research on roll contour and control strategy for edge drop control of high-strength steel in the cold rolling precision mill

EEMD-Based Steady-State Indexes and Their Applications to Condition Monitoring and Fault Diagnosis of Railway Axle Bearings

Online deviation measurement system of the strip in the finishing process based on machine vision

Online Partition-Cooling System of Hot-Rolled Electrical Steel for Thermal Roll Profile and Its Industrial Application