Abstract:This article proposes a configurable supply mechanism in the power stage to simultaneously improve the load transient response and power conversion efficiency. The power stage, comprising a dcdc converter and an auxiliary power circuit (APC), can be organized depending on the variable load conditions. During step-load changes, the APC can provide an additional charging or discharging current to the output capacitance of the dcdc converter to compensate for any differences between the load current and inductor current. Meanwhile, two auxiliary transient transistors are employed to immediately adjust the output level of the error amplifier because the peak current-mode control is used in the dcdc converter. Thus, the recovery time and output transient ripple are enhanced significantly. At the steady state, the APC is inactivated; thus, the conversion efficiency of the dcdc converter does not degenerate. Above medium loads, only the dcdc converter is activated to deliver adequate power with high efficiency. At light loads, the APC acts as a linear regulator to take over the energy delivery scheme because power consumption is reduced effectively while the output voltage is kept. Therefore, the hybrid operation can guarantee improvements in load transient response and power conversion efficiency at light loads. The proposed converter was fabricated with 0.35-m CMOS technology. The experimental results showed that the recovery times for 450-mA step-down and step-up loads are 1.6 and 2.0 s, respectively. Comparing to when the transient mode is disabled, the recovery time of the output voltage is improved by over ten times when the transient mode is enabled. Further, the efficiency improvements with the proposed method at load current of 20 mA under the output voltages of 2.5 V and 1.8 V are 13.8 and 4.9, respectively.

Voltage Regulator Buck Converter with a Tapped Inductor for Fast Transient Response Application

A Voltage Mode Buck Converter with Fast Transient Response

Coupled Inductor Based Zero-Voltage-switching Buck/boost Converter

A New Improved Ultra-Fast-Response Low-Transient-Voltage Buck Converter With Transient-Acceleration Loops and V-Cubic Techniques

A ZVS Buck/Boost Converter With Coupled-Filter-Inductor

A Fast-Response BUCK Converter with Adaptive Detect and Transient Enhancement Techniques.

A Dynamic Buck Converter with Ultra Fast Response and Low Voltage Ripples Designed for Dvs Systems

A Fast Transient Current-Mode Buck Converter With Linear Regulation Mode

Single-Inductor–Multiple-Tier Regulation: TSV-Inductor-Based On-Chip Buck Converters for 3-D IC Power Delivery

A Fast Transient Response Synchronous Buck Converter with Modified Ripple-Based Control (MRBC) Technique

An Inductance-Variation-Insensitive Buck Converter Using a Dynamic Ramp Compensation With Slope Sensing Technique

A Fast Transient Response Slope-Adjusted Voltage Mode Buck Converter

Step-Down Magnetic Integrated Dc-Dc Converter For Low Current Ripple And High Power Density Applications

Inverter-Based Fast Transient Response Capacitor-Less LDO

A Fast Transient Adaptive On-Time Controlled BUCK Converter with Dual Modulation

An Input-Output Regulated Adaptive Ramp for Fast Load Transition of PWM Buck Convertor.

A Dual-Mode Single-Inductor Dual-Output Dc-Dc Converter With Fast Transient Response

An Improved Optimum-Damping Current-Mode Buck Converter With Fast-Transient Response and Small-Transient Voltage Using New Current Sensing Circuits

Design-oriented fast response voltage mode buck converter with adaptive ramp control

A Fast-Response RBAOT-Controlled Buck Converter With Pseudofixed Switching Frequency and Enhanced Output Accuracy

A 96.1% Efficiency Single-Inductor Multiple-Output (SIMO) Buck Converter With 2.1-A/ns Transient Speed and 2.2-A Maximum Current Capacity