Abstract:This article proposes a configurable supply mechanism in the power stage to simultaneously improve the load transient response and power conversion efficiency. The power stage, comprising a dcdc converter and an auxiliary power circuit (APC), can be organized depending on the variable load conditions. During step-load changes, the APC can provide an additional charging or discharging current to the output capacitance of the dcdc converter to compensate for any differences between the load current and inductor current. Meanwhile, two auxiliary transient transistors are employed to immediately adjust the output level of the error amplifier because the peak current-mode control is used in the dcdc converter. Thus, the recovery time and output transient ripple are enhanced significantly. At the steady state, the APC is inactivated; thus, the conversion efficiency of the dcdc converter does not degenerate. Above medium loads, only the dcdc converter is activated to deliver adequate power with high efficiency. At light loads, the APC acts as a linear regulator to take over the energy delivery scheme because power consumption is reduced effectively while the output voltage is kept. Therefore, the hybrid operation can guarantee improvements in load transient response and power conversion efficiency at light loads. The proposed converter was fabricated with 0.35-m CMOS technology. The experimental results showed that the recovery times for 450-mA step-down and step-up loads are 1.6 and 2.0 s, respectively. Comparing to when the transient mode is disabled, the recovery time of the output voltage is improved by over ten times when the transient mode is enabled. Further, the efficiency improvements with the proposed method at load current of 20 mA under the output voltages of 2.5 V and 1.8 V are 13.8 and 4.9, respectively.

A Fast Transient Response Synchronous Buck Converter with Modified Ripple-Based Control (MRBC) Technique

A Fast-Response RBAOT-Controlled Buck Converter With Pseudofixed Switching Frequency and Enhanced Output Accuracy

A 10mhz Ripple-Based On-Time Controlled Buck Converter with Dual Ripple Compensation and Real-Time Efficiency Optimization

A 10 MHz Ripple-Based On-Time Controlled Buck Converter with Dual Ripple Compensation

A 2.5 MHz, 6 A Ripple-Based Adaptive On-Time Controlled Buck Converter with Pseudo Triangular Ramp Compensation

A New Improved Ultra-Fast-Response Low-Transient-Voltage Buck Converter With Transient-Acceleration Loops and V-Cubic Techniques

A Constant On-Time Control with Internal Active Ripple Compensation Strategy for Buck Converter with Ceramic Capacitors

A Voltage Ripple Compensation Method for Constant On-Time Buck Converter

A Fast-Response BUCK Converter with Adaptive Detect and Transient Enhancement Techniques.

A Dynamic Buck Converter with Ultra Fast Response and Low Voltage Ripples Designed for Dvs Systems

A 1500ma, 10mhz On-Time Controlled Buck Converter with Ripple Compensation and Efficiency Optimization

Study on High Robustness and Fast Dynamic Response Synchronous Rectifier Buck Converter

A Fast Transient Adaptive On-Time Controlled BUCK Converter with Dual Modulation

A 1500 Ma, 10 Mhz On-Time Controlled Buck Converter with Ripple Compensation and Efficiency Optimization

A Model Reference Voltage Mode Control for Ripple Cancellation Buck Converter of Wide-Operation Range

A Fast Transient Response Slope-Adjusted Voltage Mode Buck Converter

A Capacitor Current and Capacitor Voltage Ripple Controlled SIDO CCM Buck Converter With Wide Load Range and Reduced Cross Regulation

A Voltage Mode Buck Converter with Fast Transient Response

A Fast Transient Current-Mode Buck Converter With Linear Regulation Mode

A Design of High-power Buck Converter Based on Synchronous Rectification

An Optimal Peak Current Mode Control Scheme for Critical Conduction Mode (crm) Buck Pfc Converter