Abstract:This article proposes a configurable supply mechanism in the power stage to simultaneously improve the load transient response and power conversion efficiency. The power stage, comprising a dcdc converter and an auxiliary power circuit (APC), can be organized depending on the variable load conditions. During step-load changes, the APC can provide an additional charging or discharging current to the output capacitance of the dcdc converter to compensate for any differences between the load current and inductor current. Meanwhile, two auxiliary transient transistors are employed to immediately adjust the output level of the error amplifier because the peak current-mode control is used in the dcdc converter. Thus, the recovery time and output transient ripple are enhanced significantly. At the steady state, the APC is inactivated; thus, the conversion efficiency of the dcdc converter does not degenerate. Above medium loads, only the dcdc converter is activated to deliver adequate power with high efficiency. At light loads, the APC acts as a linear regulator to take over the energy delivery scheme because power consumption is reduced effectively while the output voltage is kept. Therefore, the hybrid operation can guarantee improvements in load transient response and power conversion efficiency at light loads. The proposed converter was fabricated with 0.35-m CMOS technology. The experimental results showed that the recovery times for 450-mA step-down and step-up loads are 1.6 and 2.0 s, respectively. Comparing to when the transient mode is disabled, the recovery time of the output voltage is improved by over ten times when the transient mode is enabled. Further, the efficiency improvements with the proposed method at load current of 20 mA under the output voltages of 2.5 V and 1.8 V are 13.8 and 4.9, respectively.

A 10 MHz Ripple-Based On-Time Controlled Buck Converter with Dual Ripple Compensation

A 10mhz Ripple-Based On-Time Controlled Buck Converter with Dual Ripple Compensation and Real-Time Efficiency Optimization

A 1500ma, 10mhz On-Time Controlled Buck Converter with Ripple Compensation and Efficiency Optimization

A 2.5 MHz, 6 A Ripple-Based Adaptive On-Time Controlled Buck Converter with Pseudo Triangular Ramp Compensation

A 1500 Ma, 10 Mhz On-Time Controlled Buck Converter with Ripple Compensation and Efficiency Optimization

A 2mhz Constant-Frequency AOT V-2 Buck Converter with Adaptive Dead Time Control for Data Centers

A Fast-Response RBAOT-Controlled Buck Converter With Pseudofixed Switching Frequency and Enhanced Output Accuracy

A Voltage Ripple Compensation Method for Constant On-Time Buck Converter

A Fast Transient Adaptive On-Time Controlled BUCK Converter with Dual Modulation

A 2 MHz buck converter with dual-mode control for Power Management Unit

A New Improved Ultra-Fast-Response Low-Transient-Voltage Buck Converter With Transient-Acceleration Loops and V-Cubic Techniques

Design Considerations of Soft-Switched Buck PFC Converter With Constant On-Time (COT) Control

Buck Converter with Load Adaptive Losses and 256x sub-mW Load Transient Response Time of 0.8 ms using Synchronous Control

4.3 an 87%-Peak-efficiency DVS-capable Single-Inductor 4-Output DC-DC Buck Converter with Ripple-Based Adaptive Off-Time Control.

Stacked Buck Converter: Current Ripple Elimination Effect and Transient Response

A Capacitor Current and Capacitor Voltage Ripple Controlled SIDO CCM Buck Converter With Wide Load Range and Reduced Cross Regulation

A 10-30 MHz Voltage-Mode Buck Converter With Linear Comparator-Free V2D Controller

Light-Load Efficiency Improvement of MHz RDCX Based on Output Voltage Ripple and Resonant Pulse Number Control

An Optimal Peak Current Mode Control Scheme for Critical Conduction Mode (crm) Buck Pfc Converter

Accurate Loop Gain Model of Ripple-Based Constant On-Time Controlled Buck Converters

A Fast Transient Current-Mode Buck Converter With Linear Regulation Mode