Abstract:The thermoelectric properties and crystal structure of individual electrodeposited bismuth telluride nanowires (NWs) were characterized using a microfabricated measurement device and transmission electron microscopy. Annealing in hydrogen was used to obtain electrical contact between the NW and the supporting Pt electrodes. By fitting the measured Seebeck coefficient with a two-band model, the NW samples were determined to be highly n-type doped. Higher thermal conductivity and electrical conductivity were observed in a 52 nm diameter monocrystalline NW than a 55 nm diameter polycrystalline NW. The electron mobility of the monocrystalline NW was found to be about 19% lower than that of bulk crystal at a similar carrier concentration and about 2.5 times higher than that of the polycrystalline NW. The specularity parameter for electron scattering by the NW surface was determined to be about 0.7 and partially specular and partially diffuse, leading to a reduction in the electron mean-free path from 61 nm in the bulk to about 40 nm in the 52 nm NW. Because of the already short phonon mean-free path of about 3 nm in bulk bismuth telluride, diffuse phonon-surface scattering is expected to reduce the lattice thermal conductivity of the 52–55 nm diameter NWs by only about 20%, which is smaller than the uncertainty in the extracted lattice thermal conductivity based on the measured total thermal conductivity and calculated electron thermal conductivity. Although the lattice thermal conductivity of the polycrystalline NW is likely lower than the bulk values, the lower thermal conductivity observed in this polycrystalline sample is mainly caused by the lower electron concentration and mobility. For both samples, the thermoelectric figure of merit (ZT) increases with temperature and is about 0.1 at a temperature of 400 K. The low ZT compared to that of bulk crystals is mainly caused by a high doping level, suggesting the need for better control of the chemical composition in order to improve the ZT of the electrodeposited NWs. Moreover, bismuth telluride NWs with diameter less than 10 nm would be required for substantial suppression of the lattice thermal conductivity as well as experimental verification of theoretical predictions of power factor enhancement in quantum wires. Such stringent diameter requirement can be relaxed in other NW systems with longer bulk phonon mean-free path or smaller effective mass and thus longer electron wavelength than those in bulk bismuth telluride.

Molecular Dynamics study of thermal conductivity in bismuth telluride thin films

Microstructure and thermoelectric properties of porous Bi 2 Te 2.85 Se 0.15 bulk materials fabricated by semisolid powder processing

Temperature and Size Effects on Electrical Properties and Thermoelectric Power of Bismuth Telluride Thin Films Deposited by Co-Sputtering

Revisiting the Reduction of Thermal Conductivity in Nano- to Micro-Grained Bismuth Telluride: The Importance of Grain-Boundary Thermal Resistance

Ultrafast study of carrier interaction in bismuth telluride thin film

Influence of Thermostatting on Nonequilibrium Molecular Dynamics Simulations of Heat Conduction in Solids.

Effect of Doping and Annealing on Thermoelectric Properties of Bismuth Telluride Thin Films

Origin of Low Lattice Thermal Conductivity in Promising Ternary PbmBi2S3+m (m = 1-10) Thermoelectric Materials

Effect of the interface on the mechanical properties and thermal conductivity of bismuth telluride films

Electronic structure and thermoelectric properties of bismuth telluride and bismuth selenide

High-Thermoelectric Performance of Nanostructured Bismuth Antimony Telluride Bulk Alloys

Transition of p- to n-Type Conductivity in Mechanically Activated Bismuth Telluride

Thermal and Vibrational Properties of Thermoelectric ZnSb - Exploring the Origin of Low Thermal Conductivity

Optimization and Characterization of Thermoelectric Properties in Selenium-Doped Bismuth Telluride Ultra Thin Films

Thermoelectric and Structural Characterizations of Individual Electrodeposited Bismuth Telluride Nanowires

Enhanced thermoelectric efficiency in nanocrystalline bismuth telluride nanotubes.

The Thermoelectric Properties of n-Type Bismuth Telluride: Bismuth Selenide Alloys Bi2Te3- x Se x

Numerical and model predictions of the thermal conductivity of bismuth telluride nanoprism-assembled films

Thermoelectric Properties of Thin Films of Bismuth Telluride Electrochemically Deposited on Stainless Steel Substrates

Thermoelectric performance of films in the bismuth-tellurium and antimony-tellurium systems

Experimental determination of phonon thermal conductivity and Lorenz ratio of single-crystal bismuth telluride