Abstract:Strain sensors, especially fiber Bragg grating (FBG) sensors, are of great importance in structural health monitoring, mechanical property analysis, and so on. Their metrological accuracy is typically evaluated by equal strength beams. The traditional strain calibration model using the equal strength beams was built based on an approximation method by small deformation theory. However, its measurement accuracy would be decreased while the beams are under the large deformation condition or under high temperature environments. For this reason, an optimized strain calibration model is developed for equal strength beams based on the deflection method. By combining the structural parameters of a specific equal strength beam and finite element analysis method, a correction coefficient is introduced into the traditional model, and an accurate application-oriented optimization formula is obtained for specific projects. The determination method of optimal deflection measurement position is also presented to further improve the strain calibration accuracy by error analysis of the deflection measurement system. Strain calibration experiments of the equal strength beam were carried out, and the error introduced by the calibration device can be reduced from 10 με to less than 1 με. Experimental results show that the optimized strain calibration model and the optimum deflection measurement position can be employed successfully under large deformation conditions, and the deformation measurement accuracy is improved greatly. This study is helpful to effectively establish metrological traceability for strain sensors and furthermore improve the measurement accuracy of strain sensors in practical engineering scenarious.

Online Curvature Calibration for Flexible Structure Deformation Detection Based on the Finite Element Method

Measurement of deformed surface and key data processing based on reverse engineering

Deformation Monitoring and Shape Reconstruction of Flexible Planer Structures Based on FBG

FOSS-Based Method for Thin-Walled Structure Deformation Perception and Shape Reconstruction

An Electronic Skin Strain Sensor for Adaptive Angle Calculation

Spatial Shape Reconstruction Using Orthogonal Fiber Bragg Grating Sensor Array

Research on Curved Surface Fitting Algorithm Based on Orthogonal Curvilinear Nets

EasyCalib: Simple and Low-Cost In-Situ Calibration for Force Reconstruction with Vision-Based Tactile Sensors

A Real-Time Spatial Deformation Estimation Method Based on Spatial Curvature Decomposition and Interpolation

Two-Step Calibration Method for Inverse Finite Element with Small Sample Features.

An Online Measurement and Calibration Method for a Radio Telescope Sub-Reflector Support Structure Using Fiber Bragg Grating

Three dimensional reconstruction of curved shape based on curvature fiber optic sensor

An Effective Deformation Measurement Method for Distorted Elements in Mindlin Plates

Shape Reconstruction of FBG Intelligent Flexible Structure Based on B-spline Fitting

Two-Dimensional Deformation Estimation of Beam-Like Structures Using Inverse Finite-Element Method: Theoretical Study and Experimental Validation

Design and Calibration of Single Stria Section Contour Sensor

Research on a Precision Calibration Model of a Flexible Strain Sensor Based on a Variable Section Cantilever Beam

Multi-level deformation behavior monitoring of flexural structures via vision-based continuous boundary tracking: proof-of-concept study

Calibration of Stereo-Digital Image Correlation for Deformation Measurement of Large Engineering Components

An in-situ self-calibration method for non-contact full-field strain measurement

Calibration Model Optimization for Strain Metrology of Equal Strength Beams Using Deflection Measurements