Abstract:We systematically investigate the influence of the fabrication process on dielectric loss in aluminum-on-silicon superconducting coplanar waveguide resonators with internal quality factors ($Q_i$) of about one million at the single-photon level. These devices are essential components in superconducting quantum processors; they also serve as proxies for understanding the energy loss of superconducting qubits. By systematically varying several fabrication steps, we identify the relative importance of reducing loss at the substrate-metal and the substrate-air interfaces. We find that it is essential to clean the silicon substrate in hydrogen fluoride (HF) prior to aluminum deposition. A post-fabrication removal of the oxides on the surface of the silicon substrate and the aluminum film by immersion in HF further improves the $Q_i$. We observe a small, but noticeable, adverse effect on the loss by omitting either standard cleaning (SC1), pre-deposition heating of the substrate to 300$°$C, or in-situ post-deposition oxidation of the film's top surface. We find no improvement due to excessive pumping meant to reach a background pressure below $6{\times} 10^{-8}$ mbar. We correlate the measured loss with microscopic properties of the substrate-metal interface through characterization with X-ray photoelectron spectroscopy (XPS), time-of-flight secondary ion mass spectroscopy (ToF-SIMS), transmission electron microscopy (TEM), energy-dispersive X-ray spectroscopy (EDS), and atomic force microscopy (AFM).

Correlation Between Propagation Loss and Silicon Dioxide Film Properties for Surface Acoustic Wave Devices

Thickness Dependence of Properties of Plasma-Deposited Amorphous SiO2 Films

Properties of plasma-deposited amorphous SiO2 films

Study of plasma-deposited amorphous SiO2 films using infrared absorption techniques

Deposition of Dense SiO2 Thin Films for Electrical Insulation Applications by Microwave ECR Plasma Source Enhanced RF Reactive Magnetron Sputtering

Optical Properties Study of Silicon Oxynitride Films Deposited by RF Magnetron Sputtering

Investigating Substrate Loss in MEMS Acoustic Resonators and On-Chip Inductors

Evolution of Optical Constants of Silicon Dioxide on Silicon from Ultrathin Films to Thick Films

Surface Acoustic Wave Devices Based on High Quality Temperature-Compensated Substrates

Effect of ionic oxygen concentration on properties of SiO2 and Ta2O5 monolayers deposited by ion beam sputtering

Optical loss by surface transfer doping in silicon waveguides

Laser Annealing of SiO2 Film Deposited by ICPECVD for Fabrication of Silicon Based Low Loss Waveguide

Characterization of process-related interfacial dielectric loss in aluminum-on-silicon by resonator microwave measurements, materials analysis, and imaging

Investigation of the Properties of Surface Acoustic Waves in a Lithium Niobate Single Crystal with a Silicon Dioxide Film by the Finite-Element Method

Effects of Substrate Temperature on the Properties of Silicon Oxide Films by PECVD

ZnO film for application in surface acoustic wave device

Temperature-Compensated High-Frequency Surface Acoustic Wave Device

Exploring Low-Loss Surface Acoustic Wave Devices on Heterogeneous Substrates

Low-loss waveguides on Y-cut thin film lithium niobate: towards acousto-optic applications

Comparative Study on Microfluidic Performance of ZnO Surface Acoustic Wave Devices on Various Substrates

Temperature stable amorphous-TeO2∕36°–46° Y-X LiTaO3 substrates for surface acoustic wave applications