Abstract:This paper presents a detailed design of a broadband power amplifier (PA) utilizing 0.18-μm CMOS technology, operating in the frequency range of 2–5 GHz. This ultra-wideband (UWB) power amplifier uses a cascode topology with current reuse to enhance gain over the desired frequency band, utilizing an inductive source degenerate design to achieve the best linearity and output power and gain while maintaining a wide bandwidth. The inductive source degenerate adopts bondwire and microstrip line design. The paper includes extensive analysis, simulation results, and measurements to verify the performance of the amplifier and demonstrate its suitability for broadband power amplifier applications. The measured results for the proposed UWB power amplifier show excellent performance, with an impressive third-order input intercept point (IIP3) ranging from 15 to 18.7 dBm over the frequency range of 2–5 GHz. The output third-order intercept point (OIP3) ranges from 33 to 35 dBm. Additionally, the gain flatness is specified as 12.5 ± 1.5 dB. The reverse isolation is greater than or equal to − 40 dBm. The PA has a P 1dB output power (OP 1dB ) of 10.2 dBm at 3 GHz, 9.2 dBm at 4 GHz, and 9.2 dBm at 5 GHz, respectively. The PA has a P 1dB power-added efficiency of 30.5% at 3 GHz, 23% at 4 GHz, and 22% at 5 GHz with a 50 Ω load termination. The power dissipation is 33.3 mW at a supply voltage of 1.8 V. In addition, the PA has an excellent small group delay variation of ± 65 ps. The chip area is 1.01 × 1.08 mm 2 , including the pads. The proposed UWB PA demonstrates exceptional linearity, efficiency, and group delay in the 2–5 GHz frequency band.

A wideband linear CMOS power amplifier design for 2.3-GHz and 2.6-GHz m-WiMAX system

Fully integrated pseudo differential K-band power amplifier in 0.13um standard CMOS

A 60GHz power amplifier with 12.1 dBm & P1dBCP in 0.18um SiGe BiCMOS process

A W-band current combined power amplifier with 14.8dBm Psat and 9.4% maximum PAE in 65nm CMOS

A 30Mhz-3Ghz 1W Stacked-Fet GaAs MMIC Power Amplifier.

Two-Way Current-Combining -Band Power Amplifier in 65-nm CMOS

Design and Analysis of a 26–34.5-Ghz Power Amplifier with Balanced Mismatch Reduction and Interstage Matching

A 60-GHz power amplifier with efficiency enhancement at power back-off

A 100–117 GHz W-Band CMOS Power Amplifier With On-Chip Adaptive Biasing

A 68.5~90 GHz High-Gain Power Amplifier with Capacitive Stability Enhancement Technique in 0.13 Μm SiGe BiCMOS

A 22.8 GHz to 32.8 GHz Compact Power Amplifier with a 15 Dbm Output P1dB and 36.5% Peak PAE in 65-Nm CMOS.

A Highly Linear, Low Power, Highly Efficient, CMOS Wideband Power Amplifier for 2–5 GHz Wireless Communications

The design and realization of a highly linear power amplifier module for a WiMAX/WiBro (802.16e) base station

A broadband, high isolation millimeter-wave CMOS power amplifier using a transformer and transmission line matching topology

A Full Ka-Band Power Amplifier with 32.9% PAE and 15.3-Dbm Power in 65-Nm CMOS

A 32.9% PAE, 15.3 Dbm, 21.6–41.6 GHz Power Amplifier in 65nm CMOS Using Coupled Resonators

A 2.45ghz CMOS Power Amplifier with High Linearity

32.4 A 67.8-to-108.2ghz Power Amplifier with a Three-Coupled-Line-Based Complementary-Gain-Boosting Technique Achieving 442ghz GBW and 23.1% Peak PAE

A 2.4 GHz CMOS High Linear Power Amplifier

A K-band Wideband Power Amplifier in 40-Nm CMOS with 7.6-Dbm Output Power

A Compact E-Band Load-Modulation Balanced Power Amplifier Using Coupled Transmission-Line Output Network Achieving 22.1-Dbm Psat and 34.9%/12.2% Efficiency at Psat/6-dB PBO