Abstract:Abstract The increase of gate leakage current when the gate dielectric layer is thinned is a key issue for device scalability. For scaling down the integrated circuits, a thin gate dielectric layer with a low leakage current is essential. Currently, changing the dielectric layer material or enhancing the surface contact between the gate dielectric and the channel material is the most common way to reduce gate leakage current in devices. Herein, we report a technique of enhancing the surface contact between the gate dielectric and the metal electrode, that is constructing an Au/Al 2 O 3 /Si metal–oxide–semiconductor device by replacing the typical evaporated electrode/dielectric layer contact with a transferred electrode/high- κ dielectric layer contact. The contact with a mild, non-invasive interface can ensure the intrinsic insulation of the dielectric layer. By applying 2–40 nm Al 2 O 3 as the dielectric layer, the current density–electrical field ( J – E ) measurement reveals that the dielectric leakage generated by the transferred electrode is less than that obtained by the typical evaporated electrode with a ratio of 0.3 × 10 1 ∼ 5 × 10 6 at V bias = 1 V. Furthermore, at J = 1 mA cm −2 , the withstand voltage can be raised by 10 0 –10 2 times over that of an evaporated electrode. The capacitance–voltage ( C – V ) test shows that the transferred metal electrode can efficiently scale the equivalent oxide layer thickness (EOT) to 1.58 nm, which is a relatively smaller value than the overall reported Si-based device’s EOT. This finding successfully illustrates that the transferred electrode/dielectric layer’s mild contact can balance the scaling of the gate dielectric layer with a minimal leakage current and constantly reduce the EOT. Our enhanced electrode/dielectric contact approach provides a straightforward and effective pathway for further scaling of devices in integrated circuits and significantly decreases the overall integrated circuit’s static power consumption (ICs).

A New Fabrication Procedure for Reproducibly Observing Leakage Current Reduction of SiO2 Due to Enhanced Phonon-Energy Coupling

Microstructure, optical and electrical properties of solution-derived peroxo-zirconium oxide gate dielectrics for CMOS application

Lithiation of SiO2 in Li-ion Batteries: in Situ Transmission Electron Microscopy Experiments and Theoretical Studies.

Large-scale Fabrication, 3D Tomography, and Lithium-Ion Battery Application of Porous Silicon.

Interface Optimization of Passivated Er 2 O 3 /Al 2 O 3 /InP MOS Capacitors and Modulation of Leakage Current Conduction Mechanism

Electrical Characterization of HfO2/4H-SiC and HfO2/Si MOS Structures

Interface Optimization and Transport Modulation of Sm2O3/InP Metal Oxide Semiconductor Capacitors with Atomic Layer Deposition-Derived Laminated Interlayer

Ultrathin Encapsulation Strategies with Predefined Gate Dielectric Surface Area for Flexible Crystalline Silicon Nanomembrane-Based MOS Capacitors

Interface Optimization and Performance Enhancement of Er2O3-Based MOS Devices by ALD-Derived Al2O3 Passivation Layers and Annealing Treatment

The Leakage Current Improvement of a Ni-Silicided SiGe/Si Junction Using a Si Cap Layer and the PAI Technique

Ultimate low leakage and EOT of high-κ dielectric using transferred metal electrode

Interface Chemistry and Defect State Optimization of the ErSmO/InP Heterojunction Modified by ALD-Driven Al 2 O 3 Interlayers

Enhanced Electrical Properties Of Lithography-Free Fabricated Mos2 Field Effect Transistors With Chromium Contacts

Observation of MOSFET-like behavior of a TFT based on amorphous oxide semiconductor channel layer with suitable integration of atomic layered deposited high-k gate dielectrics

Fabrication of MOSFET Capacitive Sensor using Spray Coating Method

Study on the layering phenomenon of SiC porous layer fabricated by constant current electrochemical etching

The Effect of SiO2 Precipitation in Si on Generation Currents in MOS Capacitors

Oxide Or Metal Interface Damage Improvement Of Deep Silicon Etch Process By Low Power Rf Of Low Frequency

Design on Formation of Nickel Silicide by a Low‐Temperature Pulsed Laser Annealing Method to Reduce Contact Resistance for CMOS Inverter and 6T‐SRAM on a Wafer‐Scale Flexible Substrate

A Nanoscale Analysis Of The Leakage Current In Sio(2) Breakdown

Post-CMOS Process for High-Aspect-ratio Monolithically Integrated Single Crystal Silicon Microstructures