Abstract:Polarization influences on the performance of multi-wavelength Brillouin Er3+-doped fiber laser are investigated by adjusting the polarization controller (PC) in the fiber loop mirror (FLM), where the linear laser cavity is composed of a fiber-tailed mirror and an FLM, and the stimulated Brillouin scattering (SBS) and the Er3+-doped fiber amplification (EDFA) simultaneously serve as the cavity gain. We realized 1–7 Brillouin laser lines by increasing the 980 nm pump power. For the first-order Brillouin laser, the signal–noise ratio (SNR) and optical intensity present a sinusoidal envelope; the conversion efficiency changes significantly from 0.56465 dBm/mw to 0.44975 dBm/mw by adjusting the ring's angle in the PC; the first-order SBS thresholds are 20.4 mw, 36.1 mw and 28.5 mw at different angles θ2 = 36°, 276° and 300°, respectively; flatness between the two Brillouin lasers change obviously from 2.863 dB to 41.801 dB with different ring angles; the second-order Brillouin laser is suppressed and disappears finally at Δθ2 = −64° to −84° and 106°~136° angle variation. For the fifth-order Brillouin laser, the highest-order Brillouin laser line is seriously suppressed until it disappears at some angle variations similarly. The powers and wavelength stabilities for one-, three- and seven-wavelength Brillouin fiber lasers were measured in 1 h, and the obtained Er3+-doped multi-wavelength Brillouin fiber laser (MWBFL) worked stably during that time, but the stabilities become worse with higher SBS orders.

A polarization controlled multiwavelength Er-doped fiber laser

A Multiwavelength Erbium-Doped Fiber Laser Realized by Controlling the Polarization State

Stable Multi-Wavelength Erbium-Doped Fiber Laser by Using Dispersion-Shifted Fiber

Multi-wavelength Lasing Oscillation Based on Polarization Hole Burning Effect in an Erbium-doped Fiber Laser

Multifrequency Erbium-Doped Fiber Laser Operating at Room Temperature

Multiwavelength Erbium-Doped Fiber Laser Based on an All-Fiber Polarization Interference Filter

Multiwavelength Erbium-Doped Fiber Laser Based on Nonlinear Polarization Rotation Assisted by Four-Wave-mixing

Stable Multi-Wavelength Erbium-Doped Fiber Laser Based on Dispersion-Shifted Fiber and Sagnac Loop Filter

Multiwavelength Er-doped fiber laser using an all-fiber Lyot filter

A Novel Single-Mode, Linearly Polarized, Erbium-Doped Fiber Laser with a Stabilized Frequency.

Single-polarization, switchable dual-wavelength erbium-doped fiber laser with two polarization-maintaining fiber Bragg gratings

Polarization Influence on Er3+-Doped Multi-Wavelength Brillouin Fiber Laser Based on Fiber Loop Mirror

Multi-wavelength Oscillating and Transverse Mode Switching in an All Few-Mode Fiber Laser Based on Polarization Manipulation

A Widely Tunable Dual-Wavelength Erbium-Doped Fiber Ring Laser Operating in Single Longitudinal Mode

Multiwavelength Erbium-Doped Fiber Laser Employing Nonlinear Polarization Rotation in A Symmetric Nonlinear Optical Loop Mirror

Wavelength Switchable Multi-Wavelength Erbium-Doped Fiber Laser Based on Polarization-Dependent Loss Modulation

A polarization sensitive self-excited multi-wavelength Brillouin-Erbium fiber laser without filtering devices

Stable Multiwavelength Dispersion-Tuned Actively Mode-Locked Erbium-Doped Fiber Ring Laser Using Nonlinear Polarization Rotation

Stable and uniform multiwavelength erbium-doped fiber laser using nonlinear polarization rotation

Multi-Wavelength, Passively Q-Switched, Single-Frequency Fiber Laser

Multiwavelength Erbium-Doped Fiber Laser Based on Intensity-Dependent Transmission in a Linear Cavity