Abstract:Shunt active power filters are the most viable solution for solving current harmonic, reactive power compensation, and load unbalancing problems widely presented in electrical distribution systems. In this article, development and implementation of a digital signal processor based three-phase four-wire shunt active power filter are analyzed to compensate non-linear and unbalanced loads under non-ideal supply voltages conditions. The proposed algorithm is divided into two parts, the first associated with the calculation of the positive-sequence component of unbalanced supply voltage and second deriving a simple and attractive fundamental extraction filter to extract the fundamental frequency component from distorted positive-sequence voltage. Average power and DC-link energy balance methods are used to calculate peak value of the supply current, which is required to flow from source to load. The behavior and effectiveness of the proposed control algorithm has been verified by simulation using MATLAB/Simulink (The MathWorks, Natick, Massachusetts, USA) environment for different cases of supply voltage. A laboratory prototype has been developed to verify the simulation results. The control scheme is realized using a TMS320F28335 floating-point digital signal processor (Texas Instruments, Dallas, Texas, USA) based system. It is found that simulated and experimental harmonic spectral performances are in compliance with the recommendations about harmonic limits imposed by the IEEE-519 Standard.

Design and performance of an active power filter for unbalanced loads

Optimized Design of AC Side Filter Inductance in Shunt Active Power Filter

Analysis of a Novel Hybrid Series Active Power Filter Topology

A shunt active power filter with control method based on neural network

Design of LCL-Filter Based Three-level Active Power Filter

Research on compensation performance of a single-phase shunt active power filter

Boost-type Inverter-Less Shunt Active Power Filter for VAR and Harmonic Compensation

Approaches to Shunt Active Power Filter for Application with Capacitive Nonlinear Load

Design and implementation of compound current control strategy for improved LCL-based Shunt Active Power Filter

Study on Shunt Active Power Filter with High Quality Grid Current Waveform

A novel shunt active power filter system

A New Hybrid Active Power Filter Topology with Continuous Compensation Bandwidth and Small Active Capacity

New Hybrid Active Power Filter with Low Additive Reactive Current Injection

The AC Side Output Filter Design of Shunt Active Power Filter

Designing of a four-leg shunt active power filter

A novel AC-AC shunt active power filter without large energy storage elements

A Digital Signal Processor Based Performance Evaluation of Three-phase Four-wire Shunt Active Filter for Harmonic Elimination, Reactive Power Compensation, and Balancing of Non-linear Loads under Non-ideal Mains Voltages

A Multi-Modular Shunt Active Power Filter System and Its Novel Fault-Tolerant Strategy Based on Split-Phase Control and Real-Time Bus Communication.

A Novel Control Approach for LCL-based Shunt Active Power Filter with High Dynamic and Steady-State Performance

High precision control strategy for three-phase four-wire Shunt Active Power Filter

A DC-link Voltage Balancing Strategy Based on Controllable Neutral Current Injected for T-type Three-Level Active Power Filter