Abstract:As an important pre-treatment part of the micro-total analysis system, the micromixer that ensures the uniform mixing of samples and reagents in a short distance is essential for the improvement of the detection accuracy. Here, a type of passive planar micromixer with narrow gaps and obstacles arranged in the mixing units is proposed. The mixer utilizes the micro-jets and bent baffles to split and recombine streams and promote vortex formation, which breaks the laminar flow when the Reynolds number (Re) varies from 0.1 to 50. The performance of the unoptimized mixer decreases first and then increases with the increase of Re. However, a poor mixing quality is found in the range of 0.5 ≤ Re ≤ 15. To surmount the above shortcomings, a comprehensive geometrical study is performed on this micromixer and the effects of various parameters such as the width and length of the gap, the shape of the baffle, and mixing unit on the mixing quality and pressure drop are analyzed. The results show that the reduction of gap width and the increase of the gap length result in the improvement of mixing efficiency. The staggered Z-shaped baffles accelerate the mixing process compared to traditional V-shaped baffles owing to asymmetric flow and vortex, which leads to excellent mixing. The results also show that the octagonal mixing unit increases mixing efficiency without basically changing pressure drop because the progressive and tapered structure enhances the convection. Lastly, a novel micromixer whose mixing performance is close to 0.8 at Re = 0.5 at the short distance of 2800 µm is proposed, fabricated and tested. This work provides a reference for the development of high-efficiency mixers in the pre-processing part of the micro-total analysis system.

Study of Influence of Air Gap Generated by Middle-Span Support for the Horizontal Stirrer on the Performance of a Reverberation Chamber

The Effect of Zigzag Boundaries on the Reverberation Chamber Performance

Study of independent sampling points in a reverberation chamber with two stirrers

Experimental Study of Influence of the Impeller Spacing on Flow Behaviour of Double‐Impeller Stirred Tank

Evaluation of the Split Stirrer in Reverberation Chamber

Effect of Agitation on the Fluidization Behavior of a Gas–solid Fluidized Bed with a Frame Impeller

A Fast Technique to Evaluate Uniformity Conformity to Standards' Requirement for a Reverberation Chamber at the Low End of Test Frequency

Reverberation Chamber Stirring Method Based on Phased Array Antenna and Frequency Stirring Techniques

Experimental and Numerical Study on Flow Resistance and Bubble Transport in a Helical Static Mixer

A mechanical mode-stirred reverberation chamber with chaotic geometry

A Note on Using Panel Diffusers to Improve Sound Field Diffusivity in Reverberation Rooms below 100 Hz

Numerical Study of Solid Particle Erosion in a Cavity with Different Wall Heights

Performance Investigation of Micromixer with Spiral Pattern on the Cylindrical Chamber Side Wall

Enhancing Mixing of Particles by Baffles in A Rotating Drum Mixer

Numerical Investigation of the Wall Effect on Airborne Particle Dispersion in A Test Chamber

Numerical Simulation on Fluid Mixing by Effects of Geometry in Staggered Oriented Ridges Micromixers

Investigation of effects of impeller geometry on the spatial distribution of turbulent field and micro-mixing performance in a stirred reactor equipped with multiple impellers

Numerical and experimental investigation of mixing enhancement in the passive planar mixer with bent baffles

Performance optimisation of small reverberant room with hanging diffusers

The Influence of Two Different Dihedral Angles on Diffuser Performance Based on LES

Experimental Study on Interference Effect of Three Risers Arranged in Tandem with Variable Spacing Ratios