Abstract:Traditional thermal prediction models of hub motor usually ignore the air thermophysical properties and focuses only on the effect of temperature variations on conductor conductivity and the performance of permanent magnets, leading inevitably to its lower prediction accuracy. In this regard, this paper proposes a revised equivalent thermal conductivity for the winding in both radial and axial directions by considering the coupled heat transfer effects between the air and the slot winding. Meanwhile, a novel magnetic-thermal bidirectional coupling model of hub motor is established, which incorporates the influence of temperature variations on wind friction loss. Compared with the traditional models, the proposed model agrees better with experimental results, and the corresponding prediction accuracy is increased by 30 %, thereby demonstrating its superiority. Furthermore, a detailed analysis is performed to investigate the effects of input current and output speed on both the temperature rise and the electromagnetic performance of the hub motor. Results reveal that as input current increases, the peak offset of motor back electromotive force decreases gradually, while the rate of decrease in average output torque accelerates with higher output speeds. It is also demonstrated that the time required for temperature to stabilize is significantly affected by the input current, while being relatively insensitive to the output speed. Moreover, as input current grows, the stabilization time of temperature rise in hub motor approximately follows the logarithmic growth pattern, whereas the stabilization time remains steady as the output speed rises.

Equivalent Stator Slot Model of Temperature Field for High Torque-Density Permanent Magnet Synchronous In-Wheel Motor

Analytical Kinetic Model for Accurate Square-slot Stator Natural Frequency Prediction

An Accurate Subdomain Model for Magnetic Field Computation in Slotted Surface-Mounted Permanent-Magnet Machines

Accurate Equivalent Modeling and Thermal Analtsis of Stator Slot of Flat Wire Motor

Research of Temperature Field Modeling for High Power-density In-wheel Motor

Thermal Modeling and Analysis of Active and End Windings of Enclosed Permanent-Magnet Synchronous In-Wheel Motor Based on Multi-Block Method

Torque Analytical Calculation of Formed Winding Permanent Magnet Motor

Analytical Modeling of High-Torque-Density Spoke-Type Permanent Magnet In-Wheel Motor Accounting for Rotor Slot and Eccentric Magnetic Pole

An Improved Hybrid Field Model for Calculating On-Load Performance of Interior Permanent-Magnet Motors

Numerical Simulation of Temperature Rise of a Direct-Driven Axial Flux Permanent Magnet Wheel Motor with Experimental Verification

Analytical torque model for a permanent magnet spherical motor using magnetic field reconstruction from measured boundary conditions

Analytical Modeling of Eddy Current Losses and Thermal Analysis of Non-Uniform-Air-Gap Combined-Pole Permanent Magnet Motors for Electric Vehicles

Thermal Simulation Analysis and Test of Low Speed Permanent Magnet Torque Motor

A novel magnetic-thermal coupling model considering air thermophysical properties for temperature rise and performance analysis of hub motor

Influence of the opening width of stator semi‐closed slot and the dimension of the closed slot on the magnetic field distribution and temperature field of the permanent magnet synchronous motor

Calculation and Experimental Study on Temperature Rise of a High OverLoad Tubular Permanent Magnet Linear Motor

Thermal Analysis of Permanent Magnet Synchronous Motor under Different Working Conditions Based on Thermal Network

Modeling and Simulation of a Novel Low-Speed High-Torque Permanent Magnet Synchronous Motor with Asymmetric Stator Slots

Improved Analytical Model of Electromagnetic Torque for Permanent Magnet Synchronous Machines

An Efficient and High Fidelity Thermal Computation Model of Permanent Magnet Synchronous Motor

Research on Inductance Parameters Of High Torque Permanent Magnet In-wheel Motor