Abstract:The insulation condition is the key to determining whether gas insulated switchgears (GISs) can operate stably and reliably. Partial discharge (PD) detection is an important technique for condition monitoring and evaluation in GIS. Acoustic emission (AE) method is commonly used in on-site PD detection. However, in field applications, there are often problems such as low signal-to-noise ratio (SNR) of measured ultrasonic signals and difficulty in extracting PD pulses. To solve this problem, a denoising method for GIS ultrasonic signals based on the combination of ultrasonic and ultra-high frequency (UHF) signals is proposed in this paper. Based on the difference in correlation between noise and PD signals, the noise in measured signal can be suppressed through accumulating and averaging of multiple ultrasonic signals, and the SNR of PD signal can be significantly improved. An actual 500-kV GIS experiment platform is established, and PD measurements for different types of defects are conducted. Then, a comparative study is conducted on the denoising performance of the proposed method and traditional denoising methods such as wavelet method and singular value decomposition (SVD) method. The results indicate that compared to traditional methods, the method proposed in this paper has a higher reduction in noise level. Especially for extremely low-SNR signals (PD pulses buried in noise), traditional methods have poor performance, while the proposed method can still extract the PD pulse form the noise. Furthermore, based on the denoised ultrasonic signals, the defect localization analysis is conducted to demonstrates the correctness of the denoising results. Finally, the proposed method is applied to on-site PD detection, which further evaluates the effectiveness of the denoising method.

Information modeling and implementation of PD monitoring of GIS based on IEC 61850

Design of the Remote Monitoring and Fault Diagnosis System for Power Electronic Equipment

A COMPUTER DISTRIBUTED PD MONITORING SYSTEM FOR 330kv GIS

Investigation of Frequency Characteristics of Typical PD and the Propagation Properties in GIS

Study on the IEC61850 Standard Applied to the On-line Monitoring of GIS

Investigation of the Evaluation of the Pd Severity and Verification of the Sensitivity of Partial-Discharge Detection Using the Uhf Method in Gis

Research on the Typical Partial Discharge Using the UHF Detection Method for GIS

Examination and Research on the Partial Discharge Fault Diagnostics in Gas Insulated Switchgear

Development and Implementation of Intelligent System for Gas Insulated Switchgear

Constuction and design of distribution management system common communication platform

Diagnosis of Partial Discharge in GIS Based on UHF Sensing Technique

Influence of the Structure Dimension of Gis on the Partial Discharge

Study and Design of Online Distributed Modeling System for China Southern Power Grid

A Denoising Method for Partial Discharge Ultrasonic Signals in GIS Based on Ultra-High Frequency Signal Synchronization

Engineering fault intelligent monitoring system based on Internet of Things and GIS

Design of Integrated EMS/DTS System Based on IEC 61970

Partial Discharge Detection and Defect Location Method in GIS Cable Terminal

Two-level Distributed Modeling of Protection Device Based on IEC 61850

Fundamentals in computer aided PD processing, PD pattern recognition and automated diagnosis in GIS

Investigation on the Sensitivity of the UHF Method for Partial Discharge Detection in GIS

Relationship Between Time-Frequency Representation of PD-induced UHF Signal and PD Current Pulse