Abstract:Electric vehicle (EV) has been regarded as not only an effective solution for environmental issues but also a more controllable and responsible device to driving forces with electric motors and precise torque measurement. For electric vehicle equipped with four in-wheel motors, its tire longitudinal forces can be generated independently and individually with fully utilized tire adhesion at each corner. This type of the electric vehicles has a distributed drive system, and often regarded as an over-actuated system since the number of actuators in general exceeds the control variables. Control allocation (CA) is often considered as an effective means for the control of over-actuated systems. The in-vehicle network technology has been one of the major enablers for the distributed drive systems.The vehicle studied in this research has an electrohydraulic brake system (EHB) on front axle, while an electromechanical brake system (EMB) on rear axle. The focus of this study is on the scheduling of the networked control for the distributed systems. A network control system (NCS) model is first established with a continuous-time based plant model, a discrete controller and a FlexRay communication model, in addition to the electric vehicle model with tire model and driving/braking actuator models.An integrated vehicle control allocation method based on constraints optimization is then proposed. The dynamic characteristics of each actuator are considered on the control allocation with higher-bandwidth actuators being used for faster control commands. It is also considered for the scheduling optimization of FlexRay which minimizes a cost function and subject to a set of constraints.Finally, a hardware-in-the-loop (HIL) system is built, which consists of a driving simulator, four in-wheel motors, EHB and EMB brake systems, all connected via FlexRay communication in order to validate the proposed scheduling methods. The experimental results have demonstrated the improved responses of actuators when considering their dynamic characteristics, improved control performance via properly designed control allocation, and reduced bus efficiency via optimized scheduling methods.

The Dynamic Studies of Dual-Motor Independent Drive Electric Vehicle with Network Control

Vehicle Dynamic Control Model and Electronic System

Study on Differential Assist Steering System with Double In-Wheel Motors with Intelligent Controller

Dynamics control of four-wheel-independent-drive electric vehicles under non-ideal onboard network conditions

Network Control of Vehicle Lateral Dynamics With Control Allocation and Dynamic Message Priority Assignment

Stability Control Strategy Design and Experiment of Distributed Electric Drive Vehicle

Network Scheduling for Distributed Controls of Electric Vehicles Considering Actuator Dynamic Characteristics

Design of New Dual-Motor Independent Drive System for Electric Vehicle

The study for brushless dc motor networked servo control techniques

Control Evaluation System Testing of Distributed Drive Electric Vehicle Handling Stability

Variable Structure Control of Electric Vehicle's Driving System with Motors in Series

A high-performance neural network vehicle dynamics model for trajectory tracking control

Dynamic Stability Control Strategy Development for an In-Wheel Motorized Electric Vehicle

Stability Sliding Mode Control for Dual-Motor Independent Drive Electric Vehicle Based on Transient Reference Model

A Study on the Performance Simulation and Control Scheme for In-wheel Motor Driven Vehicles

Dynamics simulation of dual-motor driven electric tracked vehicle

Analysis and Design of Drivetrain Control for the AEV with Network-Induced Compounding-Construction Loop Delays

Networked Motion Control for Smart EV with Multiple-Package Transmissions and Time-Varying Network-Induced Delays

Distributed driving electric vehicle lateral stability control method considering time delay

Collaborative Simulation and Test Study on Electric Drive Tracked Vehicle Dynamic Performances

An NMPC-Based Integrated Longitudinal and Lateral Vehicle Stability Control Based on the Double-Layer Torque Distribution