Abstract:The simulation of interaction between flow and the elastic structure is a complicated fluid-solid interaction problem, involving the structure's large deformation and fluid interface variation. In this paper, an adaptive CIP (constrained interpolation profile)-based numerical model has been presented to simulate this problem. In this CIP-based model, the constrained interpolation profile method, a high-order finite difference method, is employed as the base flow solver and THINC/SW (Tangent of Hyperbola for Interface Capturing with Slope Weighting) method, a volume of fluid method, is applied to capture the flow interface. IBM (immersed boundary method) method is used to treat the fluid-solid interface. The body deformation is calculated by coupled FDM-FEM (finite difference method and finite element method) method. Adaptive mesh is generated by Afivo (Adaptive Finite Volume quadtree/Octree mesh) framework. The cases of flow past a square and water entry of a symmetric solid wedge are carried out to validate the reliability of the flow solver in this present model. Cantilever beam deformation case is used to validate the accuracy of the solid solver in the present model. Then cases of a thin elastic beam in sloshing tank and dam-break flow are carried out by using this model. After that, the case of regular wave past a membrane breakwater is studied. Our numerical results are compared with previous experimental and numerical studies, and good agreements are obtained. It is demonstrated that this present numerical model has good applicability to simulate the interaction between flow and a thin elastic beam.

Fluid Structure Interaction Analysis and Simulation of Micromachined Cantilever-Based Flow Sensor

Design and Fluid–structure Interaction Analysis of a Micromachined Cantilever-Based Differential Pressure Flow Sensor

Analysis of the Flow Characteristics of Diffuser/Nozzle Based on MEMS

Design, Simulation and Fabrication of a Micromachined Cantilever-Based Flow Sensor

Simulations of Interaction Between Flow and a Thin Elastic Beam Using Cip-Based Model with Adaptive Mesh

Simplified Aeroelastic Model for Fluid Structure Interaction Between Microcantilever Sensors and Fluid Surroundings

Multi-physics Analysis of an Electrostatically Actuated Microcantilever in Viscous Fluids

Design and Simulation Analysis of Microscale Fluidic Flow Sensor

Design and development of MEMS based beam-membrane structure flow sensor

Principle and Application of Silicion Micromachined Fluid Sensor Based on MEMS

SIMULATION AND MICRO-PIV RESEARCH ON CLASSICAL MICROCHANNEL FLOW

Integrated 3d Multi-Physical Simulation of A Microfluidic System Using Finite Element Analysis

The Fabrication and Integration of a Novel Shear Stress Sensor Array and Its Wind Tunnel Test

Numerical Investigation of Nonlinear Fluid–structure Interaction Dynamic Behaviors under a General Immersed Boundary-Lattice Boltzmann-Finite Element Method

Theoretical and Experimental Studies of a Surface Acoustic Wave Flow Sensor.

Simulation and optimization of a micro flow sensor

Fluid-Structure Interaction Simulation of a Coriolis Mass Flowmeter using a Lattice Boltzmann Method

Modeling and Simulation of Airflow Level Posture Sensor

Simulation Study on MEMS V-cone Sensor in Hydraulic System

Modeling and Simulation of Flexible Vector Shear Flow Sensor Based on COMSOL Multiphysics.

A Micromachined Single-Crystal Silicon Flow Sensor with a Cantilever Paddle