Abstract:In contrast to traditional 60 Hz transformer, solid state transformer (SST) offers power flow control, integration of renewables and maintaining grid stability in high renewable penetration scenario. Like a typical power converter, SST requires low voltage (24 V dc) power for its control and sensing circuits. In running condition, this power is derived from its low voltage dc bus at 400 V. But it is challenging to derive it during start-up, because the only source available during start-up is the distribution grid at 7.2 kV, 60 Hz. Due to high input voltage (7.2 kV, 60 Hz), deriving a control supply of about 150 W, even for just start-up duration of about 200 ms, presents a novel power electronics problem. In this paper, two solutions have been proposed to address this issue, by taking a 20 kVA, 6.5 kV Si IGBT and 15 kV SiC MOSFET based SSTs as the reference converters. The first solution is generic and is based on storing the required start-up energy in a dc capacitance. This is based on developing a cost-effective high voltage switch using low voltage IGBTs with self-driven functionality. The second solution, applicable only to SST topologies with high voltage ac capacitive filter, is to tap the energy from the capacitor itself. The fundamental constraints considered for both the solutions are practical feasibility at high voltage (7.2 kV ac or over 10 kV dc), power loss, size, weight and cost-effectiveness. Experimental validation of extracting continuous power for the IGBT gate driver ICs from the snubber is presented with 200 V input. And, the results of the auxiliary power derivation from the filter capacitor are shown with 5.7 kV ac input.

Rectifier Stage Operation and Controller Design for A Medium Voltage Solid State Transformer with Lcl Filter

Research on Voltage and Power Balance Control for Cascaded Modular Solid-State Transformer

A Five-level AC/DC Converter for MV Solid-State Transformer

500kva Hybrid Solid State Transformer (Hsst): Architecture, Functionality And Control

Voltage and power balance control for a cascaded multilevel solid state transformer

Design And Demonstration Of A Sic-Based 800-V/10-Kv 1-Mw Solid-State Transformer For Grid-Connected Photovoltaic Systems

Design and Implementation of High Efficiency Control Scheme of Dual Active Bridge Based 10 Kv/1 MW Solid State Transformer for PV Application

Comparisons of different control strategies for 20kVA solid state transformer

A Coordinate and Distributed Control Scheme for Multilevel and Multi-Stage Medium Voltage Solid State Transformer

Design and Demonstration of a 3.6kv–120v/10kva Solid State Transformer for Smart Grid Application

Versatile Control Functions of Hybrid Solid-State Transformers in Distribution Systems

Virtual Transformer Operation Of Solid State Transformer (Sst)

500Kva Hybrid Solid State Transformer (HSST): Modelling and Control

Design and Operation of A 3.6kv High Performance Solid State Transformer Based on 13kv Sic Mosfet and Jbs Diode

Parallel operation of solid state transformer

Study on Low-Frequency Ripple Voltage Suppression for Cascaded Three-Phase Solid-State-Transformer

Standalone Operation of a Single Phase Medium Voltage Solid State Transformer in Distribution Grid

3-D Space Modulation with Voltage Balancing Capability for A Cascaded Seven-Level Converter in A Solid-State Transformer

Solid State Transformer for Low-Voltage Distribution System with DC/DC Stage-Controlled Split-Capacitor

Medium Voltage Solid State Transformers Based on 15 Kv SiC MOSFET and JBS Diode.

Auxiliary power supply for Solid State Transformers