Abstract:A wideband low-noise amplifier (LNA) featuring transformer-based wideband input matching is proposed for millimeter-wave applications. By analyzing the properties of conventional series input matching networks, which were widely employed in narrowband LNAs and shunt-series matching networks for bandwidth extension, a novel input matching network possessing the merits of both was proposed. For further bandwidth extension, another peak of input impedance at a higher frequency is introduced for the proposed input matching network. Moreover, it is proved that the proposed input matching network can suppress the gate resistor noise, resulting in significant noise figure (NF) improvement of an LNA. On the other hand, the NF is further reduced by connecting a transformer between the two amplification stages, which helps suppress the noise contribution from the second stage, leading to an LNA design with NF lower than 4.5 dB over a very wide operating bandwidth. To enhance the gain bandwidth, the peak distribution, including both shunt peaking and series peaking, is discussed. By appropriately distributing these peaks, which is also known as the pole-tuning technique, a wider gain bandwidth can be obtained. To validate the proposed techniques, an LNA with two common-source (CS) stages is designed and fabricated using a 65-nm CMOS process, and the overall chip size, including all pads, is only 0.26 mm². The two CS stages are cascoded for dc biasing to reduce the power consumption. Experimental results show that a peak gain of 13.5 dB is achieved within a -3-dB bandwidth from 19.2 to 42.6 GHz. The measured NF is 3.1-4.5 dB, and the input 1-dB gain compression point (IP1 dB) ranges from -13.54 to -9.89 dBm in the entire gain bandwidth. The input return loss S₁₁ is less than -10 dB over a frequency range of 16.8-38.9 GHz. Moreover, benefiting from the current-reuse technique, the power consumption of the LNA is only 6.36-mW.

A Modified Architecture Used for Input Matching in CMOS Low-Noise Amplifiers

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

Miller Effect Analysis and Noise Optimization of CMOS Low Noise Amplifier

A Highly Linear 2.4GHz Low Noise Amplifier

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

A BiCMOS Implementation of Noise Canceling Low Noise Amplifier for Wideband Applications

Design and Optimization of a Milli-Meter Wave Amplifier Using Nano-Scale CMOS Devices

A dual band CMOS two-stage variable gain low noise amplifier

A 2.8–10-GHz CMOS Current Reuse Cascaded Linearity Improving Ultra-Wideband Low-Noise Amplifier

28 GHz Compact LNAs with 1.9 Db NF Using Folded Three-Coil Transformer and Dual-Feedforward Techniques in 65nm CMOS

Millimeter-Wave Low-Noise Amplifier Design in 28-nm Low-Power Digital CMOS

Wideband Inductorless Low-Power LNAs with Gm Enhancement and Noise-Cancellation.

A 7.2–27.3 GHz CMOS LNA With 3.51 ±0.21 dB Noise Figure Using Multistage Noise Matching Technique

Two-Fold Noise-Cancelling Low-Noise Amplifier in 28-nm CMOS

A Wideband Inductorless LNA with Local Feedback and Noise Cancelling for Low-Power Low-Voltage Applications

A Wideband CMOS LNA Using Transformer-Based Input Matching and Pole-Tuning Technique

A CMOS Dual-Feedback Reconfigurable Low Noise Amplifier with Improved Stability and Reduced Noise.

The Design Of Cmos Rf Low Noise Amplifiers

A 0.03-3Ghz Inductorless Wideband Low Noise Amplifier in 65nm CMOS