Abstract:Summary form only given. We describe the application of an atmospheric-pressure air plasma jet (APAPJ) source to polymer etching. The electrical and optical emission spectrum (OES) characteristics of APAPJ have been studied and analyzed. From OES measurements, it can be found that the emission intensities of metastable and ionized molecular nitrogen N2* and N2+ is stronger and the emission intensity of N2* is dominant. With the increase of power voltage, the emission intensity of excited species is increased. Based on this APAPJ source, etching of photoresist (PR) 193 nm material has been examined by using real-time ellipsometry. Etch rates increase with source voltage u and as the distance between sample and needle tip s is decreased. The influence of distance s and voltage u on etch rates is very significant. For distances of 5 mm, 8 mm and 10 mm (Singleelectrode system), the etch rates are 61.29, 20.55 and 5.47 nm/min respectively. When the voltages are increased from 7 kV to 8 kV, the etch rates are increased from 2.84 nm/min to 20.55 nm/min respectively. The etch rates are decreased when the gas flow rates are increased from 5 lpm to 15 lpm, but not significantly. In this paper, single-electrode and two-electrode systems are both adopted to etch PR material. Results show that the single-electrode system can get larger etching rates. Etched samples have been observed by microscope, the significant circular spots can be observed, which is likely to be due to the charging of samples in APAPJ discharge. The density and diameter of spots by two-electrode system is smaller than that by single-electrode system. For two-electrode system, the spots diameters will be decreased with the increase of the distance s.

Development of an atmospheric pressure air microplasma jet for the selective etching of parylene-C film

Localized Etching of Polymer Films Using an Atmospheric Pressure Air Microplasma Jet

Separated Type Atmospheric Pressure Plasma Microjets Array for Maskless Microscale Etching

Low temperature atmospheric microplasma jet array for uniform treatment of polymer surface for flexible electronics

Nonhomogeneous surface properties of parylene-C film etched by an atmospheric pressure He/O 2 micro-plasma jet in ambient air

Atmospheric-pressure air plasma jet and its application to photoresist material etching

Study of uniformity of atmospheric pressure plasma microjet array for maskless parallel micropatterned etching

Direct And All-Dry Microfabrication Of Ultramicroelectrode Based On Cold Atmospheric Microplasma Jet

Development of microplasma devices arrays for maskless nanoscale material etching

SF6 Optimized O2 Plasma Etching of Parylene C

DIRECT AND ALL-DRY FABRICATION OF PAPER-BASED MICROFLUIDIC DEVICE USING PARYLENE-C DEPOSITION AND MASKLESS MICROPLASMA WRITING

Development of A Cold Atmospheric Pressure Microplasma Jet for Freeform Cell Printing

Fabrication and operation of microplasma reactor array for maskless nanoscale material etching

Micro Etching Method Inside Microchannels

A study on the etching characteristics of atmospheric pressure plasma for single-crystal silicon wafer

SF₆ Optimized O₂ Plasma Etching of Parylene C.

An Experimental Study of Photoresist Material Etching by an Atmospheric-Pressure Plasma Jet with Ar/air Mixed Gas

A SIMPLE AND FLEXIBLE ATMOSPHERIC MICROPLASMA GENERATION DEVICE WITH PATTERNABLE MICROFLUIDIC CHANNELS

Fabrication and Performance of Microplasma Reactor for Maskless Scanning Plasma Etching

Effect of metal mesh addition on polymer surface etching by an atmospheric pressure plasma jet

Characterization of inverted pyramidal hollow cathode microplasma devices operating in reactive gases for maskless scanning plasma etching