Abstract:The determination of the traffic carrying capacity of road network is of great significance to the scale control of urban vehicles and the control of transportation systems. Existing related works have proposed calculation models and solutions for different application environments. However, these studies have problems such as diversification of capacity definitions, incorrect analysis of factors, and excessive model constraints. In response to these problems, this paper aims to determine the connotation of traffic carrying capacity and put forward a novel calculation model for carrying capacity. Firstly, in-depth analysis found that the key factor affecting the number of vehicles is the service level of road network. Then, the connotation of traffic carrying capacity is clarified, that is, the maximum number of vehicles travelling simultaneously in the road network under a certain service level. Second, based on the definition of carrying capacity and the characterization relationship between average travel speed and service level, the calculation of carrying capacity is transformed into the establishment of relationship between average travel speed and maximum number of vehicles. The construction of this relationship includes five steps, which are proposal of equivalent lane, division of traffic basic units, construction of basic unit travel time model, calculation of basic unit carrying capacity, and calculation of road network carrying capacity. In particular, the proposal of equivalent lane achieves the conversion from intermittent flow to continuous flow, and the abstraction of traffic flow further unifies the operation process into a unified mode of free travel and stacked release. Finally, the VISSIM simulation software is employed to verify and evaluate the proposed models. The results show that the average relative error between the simulated data and the calculated data obtained from the model is -0. 46%. Findings from this study will provide an innovative idea for the evaluation of urban road network performance. It can also provide a basis for urban managers to improve service level of road network and optimize the design of transportation system.

Capacity of through short lane group on urban road intersection

Modeling Capacity at Signalized Intersections with a Left-Turn Storage Bay Considering Signal Timing Plan

Capacity of Urban Arterial Weaving Sections under Lane Signal Control Strategy

Capacity of unsignalized intersection with mixed distribution headway

Modeling Capacity of Shared Right-Turn Lanes at Signalized Intersections Considering the Lag Green Time of Right-Turns

Modeling capacity of shared right-turn lanes considering right turn on red and lag green time of right-turn

Method of computing left-turn vehicle traffic capacity at two-phase intersection

Analysis of Traffic Flow Characteristics under Large Volume in Highway Tunnel Group Region

Influence of signal on the capacity of signalized intersection

Configuration of Spatial-temporal Resources at Intersections Considering Travel Efficiencies of Mixed Flows

Evaluation of signaled intersection status under capacity of sections

Passing Capacity of Advance Right-Turn Motor Vehicles

Capacity Analysis of Intersections When CAVs Crossing in a Collaborative and Lane-Free Order

Planning methods and effect analysis of advance right-turn

Study on the Capacity of Left-Through Shared Lane with Permitted Left-Turn Phasing

Modeling of urban road network traffic carrying capacity based on equivalent traffic flow

Conflict delay models at two-phase intersection

Intersection control strategy optimization based on exchangeable lanes modeling

A study on the capacity of exclusive right-turn lanes of at-grade intersections

Traffic flow capacity model for urban expressways

Critical Traffic Volume of Traffic Signal Warrant at Major-Minor Intersections