Abstract:The determination of the traffic carrying capacity of road network is of great significance to the scale control of urban vehicles and the control of transportation systems. Existing related works have proposed calculation models and solutions for different application environments. However, these studies have problems such as diversification of capacity definitions, incorrect analysis of factors, and excessive model constraints. In response to these problems, this paper aims to determine the connotation of traffic carrying capacity and put forward a novel calculation model for carrying capacity. Firstly, in-depth analysis found that the key factor affecting the number of vehicles is the service level of road network. Then, the connotation of traffic carrying capacity is clarified, that is, the maximum number of vehicles travelling simultaneously in the road network under a certain service level. Second, based on the definition of carrying capacity and the characterization relationship between average travel speed and service level, the calculation of carrying capacity is transformed into the establishment of relationship between average travel speed and maximum number of vehicles. The construction of this relationship includes five steps, which are proposal of equivalent lane, division of traffic basic units, construction of basic unit travel time model, calculation of basic unit carrying capacity, and calculation of road network carrying capacity. In particular, the proposal of equivalent lane achieves the conversion from intermittent flow to continuous flow, and the abstraction of traffic flow further unifies the operation process into a unified mode of free travel and stacked release. Finally, the VISSIM simulation software is employed to verify and evaluate the proposed models. The results show that the average relative error between the simulated data and the calculated data obtained from the model is -0. 46%. Findings from this study will provide an innovative idea for the evaluation of urban road network performance. It can also provide a basis for urban managers to improve service level of road network and optimize the design of transportation system.

Analysis of Traffic Flow Characteristics under Large Volume in Highway Tunnel Group Region

Prediction of Traffic Volume in Highway Tunnel Group Region Based on Grey Markov Model

The Quantitative Analysis of the Level of Service of Two-lane Highways Based on Overtaking Ratio

Analysis of Gray-Markov Forecasting for Traffic Accidents in Highway Tunnel Group Region

Application of Catastrophe Theory in Traffic Flow of Highway Tunnel Group

Empirical Analysis of Traffic Bottleneck at Beijing Expressways

Critical Traffic Volume of Traffic Signal Warrant at Major-Minor Intersections

Critical Traffic Volume Warrant of Signal Installing at Equal Weight Intersections

Traffic flow capacity model for urban expressways

A Novel Highway Traffic Capacity Analyzing Method under Road Region Atmospheric Environment Constrains Based on Computational Fluid Dynamics Model

Equivalent Queue Length Change Rate Models for Congested Traffic Flow

Empirical Analysis of Traffic Flow Characteristics at Variable Approach Lanes

MEASURED DATA ANALYSIS OF URBAN EXPRESSWAY AND RESEARCH ON TRAFFIC FLOW MODELS

Analysis of Car-Following Behaviors under Different Conditions on the Entrance Section of Cross-River and Cross-Sea Tunnels: A Case Study of Shanghai Yangtze River Tunnel

Study on the Method of Traffic State Change Time on Urban Expressway

Modeling of urban road network traffic carrying capacity based on equivalent traffic flow

Critical traffic volume of traffic signal warrant under limited priority condition

Capacity of unsignalized intersection with mixed distribution headway

Traffic Speed-Flow Model for the Mix Traffic Flow on Beijing Urban Expressway

Study on Traffic Flow Measurings of Two 4-lane Intercity Highways

Traffic Flow Headway Distribution and Capacity Analysis Using Urban Arterial Road Data