Abstract:Gas explosion in connected vessels usually leads to high pressure and high rate of pressure increase which the vessels and pipes can not tolerate. Severe human casualties and property losses may occur due to the variation characteristics of gas explosion pressure in connected vessels. To determine gas explosion strength, an experimental testing system for methane and air mixture explosion in a single vessel, in a single vessel connected a pipe and in connected vessels has been set up. The experiment apparatus consisted of two spherical vessels of 350 mm and 600 mm in diameter, three connecting pipes of 89 mm in diameter and 6 m in length. First, the results of gas explosion pressure in a single vessel and connected vessels were compared and analyzed. And then the development of gas explosion, its changing characteristics and relevant influencing factors were analyzed. When gas explosion occurs in a single vessel, the maximum explosion pressure and pressure growth rate with ignition at the center of a spherical vessel are higher than those with ignition on the inner-wall of the vessel. In conclusion, besides ignition source on the inner wall, the ignition source at the center of the vessels must be avoided to reduce the damage level. When the gas mixture is ignited in the large vessel, the maximum explosion pressure and explosion pressure rising rate in the small vessel raise. And the maximum explosion pressure and pressure rising rate in connected vessels are higher than those in the single containment vessel. So whenever possible, some isolation techniques, such as fast-acting valves, rotary valves, etc., might be applied to reduce explosion strength in the integrated system. However, when the gas mixture is ignited in the small vessel, the maximum explosion pressures in the large vessel and in the small vessel both decrease. Moreover, the explosion pressure is lower than that in the single vessel. When gas explosion happens in a single vessel connected to a pipe, the maximum explosion pressure occurs at the end of the pipe if the gas mixture is ignited in the spherical vessel. Therefore, installing a pipe into the system can reduce the maximum explosion pressure, but it also causes the explosion pressure growth rate to increase. (C) 2013 Elsevier Ltd. All rights reserved.

Experimental Investigation of Gas Explosion Characteristic in Linked Vessels

Experimental Investigation And Numerical Simulation Of Gas Explosion In Linked Vessels

Experimental Research On Gas Explosion Venting Of Premixed Gases In Linked Vessels

Experimental investigation on gas explosion and venting in linked vessels

Experimental Study on Premixed Flammable Gas Explosion Venting in Linked Vessels under the Same Effictive Vent Area

Gas Explosion Venting of Premixed Gases in Linked Vessels

Experimental Investigation of Gas Explosion in Single Vessel and Connected Vessels

Experimental Investigation into Explosion of Premixed Gases in Linked Vessels

CFD Simulation on Gas Explosion Field in Linked Vessels

Experimental study on gas explosion and venting process in interconnected vessels

Numerical Analysis of Gas Explosion Process in Linked Vessels

Experimental Premixed Flammable Gas Explosion Venting in Linked Vessels with Different Pipe Length

Experimental Investigation Into Premixed Gases Explosion in Spherical Shape Vessel Added Pipes

The Experimental Study on Different Combinations of Connected Vessels in Airtight Explosion Process

Study on Premixed Flammable Gas Explosion Venting in Linked Vessels

Effects of obstacles in duct on gas explosion in linked vessels

Numerical Investigation on Explosion of Quick Actuating Pressure Vessels Due to Residual Pressure

Process Of Natural Gas Explosion In Linked Vessels With Three Structures Obtained Using Numerical Simulation

Research on overpressure hazards and flame propagation behaviors of CH4/air mixture explosions in a vessel-duct connected device

Experimental analysis of explosion in spherical vessel vented into dump vessel

Experimental and Numerical Study of Natural Gas Leakage and Explosion Characteristics.