Abstract:<p>Carbon fibre-reinforced polymer (CFRP) plates are widely used to strengthen reinforced-concrete (RC) structures. At present, most studies focused on the short-term performance of strengthened RC beams with a prestressed CFRP plate, and very limited information is available on their durability, which is of importance in certain cases, such as high-piled wharfs and bridges in marine environments. This study investigates the effects of chloride environment exposure on the flexural performance of strengthened RC beams with self-anchored prestressed CFRP plates. In total, seven RC beams, four of which were strengthened by a self-anchored prestressed CFRP plate, were fabricated and tested under three-point bending. The testing parameters included 25% and 40% prestress level of the ultimate tensile strength of the CFRP plate, 5% and 10% tensile steel rebar corrosion ratio of mass loss and 10% and 20% anchor corrosion ratio in the chloride environment. The evolution of time-dependent prestress losses in the strengthened beam was determined, and the flexural behaviour of the strengthened beams was analysed. A theoretical model is proposed to predict the flexural strength of prestressed CFRP strengthened RC beams in a chloride environment. The experimental results indicated that the coupling of the corrosion expansion of the metal anchor and rebar in the chloride environment had a large negative effect on the flexural performance of the beams strengthened by the self-anchored prestressed CFRP plates. After exposure to the chloride ion solution, the failure mode of the RC beams strengthened by the prestressed CFRP changed from concrete crushing in the compression section to anchor pullout. The proposed model, which considered the effect of a chloride environment to predict the flexural strength of the strengthened beams, agreed well with the test results.</p>

Effects on the fatigue lives of RC beams strengthened with CFL at elevated temperature under cyclic bending loads

Effect of sustaining load level on flexural behavior of RC beams retrofitted with CFRP sheets

Fatigue Crack Propagation Behavior of RC Beams Strengthened with CFRP under High Temperature and High Humidity Environment

Study on flexural performance of cracked RC beams retrofitted with CFRP sheets

Experimental and Analytical Investigation of Crack Spacing and Width for Overlaid RC Beams at Elevated Temperatures

Fatigue and durability behavior of RC beams strengthened with CFRP under hot-wet environment

Study on thermal effects on fatigue behavior of cracked steel plates strengthened by CFRP sheets

Behavior of Preloaded RC Beams Strengthened with CFRP Laminates

Fatigue Performance of Prefabricated Composite T‐beams under Cyclic Overloading: an Experimental Study

Flexural Behaviour of Reinforced Concrete Beams under Freeze–thaw Cycles and Sustained Load

Structural behavior of CFRP-strengthened steel beams at different service temperatures: Experimental study and FE modeling

Flexural Performance and Thermomechanical Coupling Analysis of Full-Iron Tailings Reinforced Concrete Beams

Numerical Analysis of High and Low‐cycle Flexural Fatigue for Reinforced Concrete Beams under Full‐range of Varying Amplitudes

Fatigue performance of RC beams strengthened with non-prestressed and prestressed BFRP grids

Residual Flexural Behaviour of RC Beams Strengthened with TRC after ISO 834 Exposure

Durability Experimental Method of RC Components Strengthened with FRP in Hot-Wet Environment

Flexural capacity of RC beams strengthened with carbon fiber sheets

An experimental study on fatigue debonding growth of RC beams strengthened with prestressed CFRP plates

Flexural behaviour and evaluation of ultra-high-performance fibre reinforced concrete beams cured at room temperature

Effect of the chloride environmental exposure on the flexural performance of strengthened RC beams with self-anchored prestressed CFRP plates

Investigation of flexure response and damage behavior of CFRP/aluminum hybrid laminates among various temperatures