Abstract:Aiming at reducing the estimation error of the sensor frequency response function (FRF) estimated by the commonly used window-based spectral estimation method, the error models of interpolation and transient errors are derived in the form of non-parameter models. Accordingly, window effects on the errors are analyzed and reveal that the commonly used hanning window leads to smaller interpolation error which can also be significantly eliminated by the cubic spline interpolation method when estimating the FRF from the step response data, and window with smaller front-end value can restrain more transient error. Thus, a new dual-cosine window with its non-zero discrete Fourier transform bins at -3, -1, 0, 1, and 3 is constructed for FRF estimation. Compared with the hanning window, the new dual-cosine window has the equivalent interpolation error suppression capability and better transient error suppression capability when estimating the FRF from the step response; specifically, it reduces the asymptotic property of the transient error from O(N-2) of the hanning window method to O(N-4) while only increases the uncertainty slightly (about 0.4 dB). Then, one direction of a wind tunnel strain gauge balance which is a high order, small damping, and non-minimum phase system is employed as the example for verifying the new dual-cosine window-based spectral estimation method. The model simulation result shows that the new dual-cosine window method is better than the hanning window method for FRF estimation, and compared with the Gans method and LPM method, it has the advantages of simple computation, less time consumption, and short data requirement; the actual data calculation result of the balance FRF is consistent to the simulation result. Thus, the new dual-cosine window is effective and practical for FRF estimation. Published by AIP Publishing.

Study on spectral leakage suppression and improved dielectric loss angle measurement method

Study on high accurate dielectric loss angle measurement method considering noise

Dielectric Loss Measurement Method Based on Quasi-synchronous DFT

Study on the Tangent Calculation Method of Frequency-domain Dielectric Loss Angle Based on Improved Kalman Filtering Algorithm

Research on non-synchronous sampling errors in electric power system

Study on the Approachs of Electrical Harmonic Analysis for Asynchronous Sampling

Investigation of Heterodyne Interferometer Technique for Dynamic Angle Measurement: Error Analysis and Performance Evaluation

Error analysis for dielectric loss factor measurement based on harmonic analysis

HW-DFT-Based Measurement Method of Frequency-Coupling Characteristics Considering Fundamental Frequency Deviation for Stability Analysis

An On-Line Detection Method of Dielectric Loss Angle Based on Matrix Pencil Algorithm

A new algorithm for electric energy measurement based on Hanning self multiplication-convolution window triple-spectrum-line interpolation FFT

A NOVEL FFT ALGORITHM FOR NONSYNCHRONOUS SAMPLE

New Precise Measurement Method of Power Harmonics Based on FFT

DFT Spectral Leakage Suppression Based on Signal Extension in Time Domain

A New Precise Measurement Method on Interharmonics

New active electric energy measurement algorithm undernon-integer-period sampling

Hanning Self-Convolution Window and Its Application to Harmonic Analysis

An Electrical Parameter Measurement System Based on DSP and LabVIEW

Error Analysis And New Dual-Cosine Window For Estimating The Sensor Frequency Response Function From The Step Response Data

Study on Digital Distortion Measurement Based on Adjusting Fundamental Frequency

Study on On-Line Monitoring of Dielectric Loss Factor for Insulation on Synthetical Relative Idea