Abstract:The solid dissolution of Fe atoms into Cu matrix induced by mechanical alloying and subsequent thermal decomposition of Fe atoms from the solid solution in composition of Fe60Cu40 have been studied by X-ray diffraction (XRD), Mossbauer spectroscopy and the extended X-ray absorption fine structure (EXAFS) technique. The disappearance of elemental Fe and Cu XRD peaks and the presence of FCC structural XRD peaks illustrate the formation of FCC-Fe60Cu40 solid solution. Meanwhile, the new sextet spectrum with a broadening hyperfine magnetic field distribution also demonstrates that the alloying is on an atomic level and there exist complex coordination environments in the solid solution. EXAFS results Further prove the reality of atomic alloying from the clear observation of Fe atoms taking on FCC coordination in the solid solution. Additionally, a large reduction in the first shell coordination number for a center iron atom but not for a center Cu atom indicates the composition non-uniformity, which suggests that Fe atoms enrich the surface while Cu atoms enrich the core of a FCC nanocrystal. The variation of Mossbauer spectra against the annealing temperatures during thermal decomposition indicates that the Fe atoms at the surface readily nucleate and cluster into alpha -Fe at a temperature slightly below 250 degreesC, whereas the Fe atoms in the core of nano-sized crystals first cluster into gamma -Fe cohering to the FCC matrix at a temperature about 350 degreesC and then transform to alpha -Fe for further annealing at a higher temperature or for a longer time. (C) 2001 Elsevier Science B.V. All rights reserved.

FMAA-MS Investigation into Ni 68 Fe 32 Nanoalloy with Sample Length Less Than 30 Mm

High-temperature Magnetic Properties of Fe-based Nanocrystalline Alloy

Investigation of fatigue mesoscopic mechanical properties of a nickel-based superalloy by instrumented microindentation measurements

Mechanical Properties of Micro-phases Along < 001 > Direction of Directionally Solidified Nickel-base Super-alloy by In-situ Nano-Indentation

Chemical Ordering Phase Transitions in Ni–Fe Nanoalloys

Ghz Microwave Permeability of Cofezr Amorphous Materials Synthesized by Two-Step Mechanical Alloying

A study of electromagnetic characteristics of Fe-Si-Al magnetic alloy

Curie Transition of NC Nickel by Mechanical Spectroscopy and Magnetization Study

Microstructures of Mechanically Alloyed Fe60Ni40 Studied by XAFS and XRD

Internal Friction of Nano-Grained Fe-25%Ni Alloy Bulk

Mechanical Alloying, Fine Structure and Thermal Decomposition of Nanocrystalline Fcc-Fe60cu40

Local Structure Evolution Of Fexni77-Xcu1-Nb2p14b6 Soft Magnetic Materials By Mechanical Alloying

Different Cr contents in nanostructured Fe-Ni-Cr alloys prepared by Mechanical Alloying

High Temperature Χac Behaviors of A Fe-Nd-B Nanocomposite Alloy

Microstructure of nano-crystalline material Al60Fe20Cu20

Measurement of Microstructural Parameters of Nanocrystalline Fe–30 Wt.%ni Alloy Produced by Surface Mechanical Attrition Treatment

Effect of the structure and volume fraction of nanophase on the mechanical properties of (FeNi)86B14 amorphous nanocrystalline alloys

Transmission electron microscopy characterization of the nanofeatures in nanostructured ferritic alloy MA957

Order-Disorder Transition and Curie Transition in Ni70fe30 Nanoalloy

Alternating Current Susceptibility Study of a Two-Phase Nanocomposite Fe88Nd6B6 Alloy in the Temperature Range 77–990 K

Saturation Magnetostriction of Α″-Fe16n2 Phase