Abstract:This paper deals with the control design of a wafer stage setup, catering for the increasing demand for ultra-precision positioning and high throughput devices in line with further miniaturization of the LCD, semiconductor and electronic parts. The developed wafer stage employs a dual stroke principle: a short stroke for fine positioning and a long stroke for coarse positioning. The short stroke is a stage of six-degree-of-freedom with integrated magnetic bearing to counteract the gravity, while the long stroke is a planar motion stage consisting of a integrated three-axis drive motor, which can move along the surface of the Halbach permanent magnet array without generating friction due to being elevated with air bearings. To achieve precision tracking control with zero settling time under high acceleration/velocity motion, iterative learning control has been regarded as an effective means. Linear iterative learning control techniques attenuate the recurring disturbances and amplify the nonrecurring, suffering from a fixed trade-off between convergence rate and noise amplification. In this paper, a frequency dependent amplitude-based nonlinear iterative learning control is proposed. Within a frequency range of interest, the learning gain is continuously updated to improve the control performance of the planar motion stage. Based on the frequency contents of error signal, for error-levels beyond a predefined threshold, additional learning gain will be effectively used to diminish the low-frequency tracking error. Below the threshold, the original low-gain value is maintained to avoid high-frequency noise amplification. Performance assessment on the developed wafer stage setup shows that the proposed nonlinear iterative learning strategy can realize a remarkable performance which includes nanometer positioning and tracking over large travel ranges, and provides a more desirable means to deal with the convergence rate and noise amplification.

QFT Iteration-Learning Based Control Strategy of Hydraulic Angular Vibration Table

The Control Strategy Study for Hydraulic Shaking Table

Research on Angular Vibration Hydraulic Table Adopting Iteration-learning-control

Control strategy for a hydraulic shaker controlled with a 3-stage electro-hydraulic servo valve

Research on the Random Shock Vibration Test Based on the Filter-X Lms Adaptive Inverse Control Algorithm

Three-variable Control Technique for a Seismic Analog Shaking Table

H<sub>∞</sub>/μ Robust Control of Vibration for an Ultra-Precision Grinding Machine

Neural Network Based Adaptive Robust Control of a Single-Axis Hydraulic Shaking Table

H∞/μ Robust Control of Vibration for an Ultra-precision Grinding Machine

Stochastic Optimal Strategy in Vibration Control for Imperfect Measurement Rotor System

Design of an Active Vibration Isolation Control Strategy Based on IFT Method

Quantitative feedback controller design and test for an electro-hydraulic position control system in a large-scale reflecting telescope

Research On The Control Strategy Of Hydraulic Shaking Table Based On The Structural Flexibility

A time-varying Q-filter design for iterative learning control with application to an ultra-precision dual-stage actuated wafer stage.

Qft Robust Control Of The Continuous Rotary Electro-Hydraulic Servo Motor

Application of QFT in Continuous Rotary Electro-Hydraulic Servo Motor

Active vibration control strategy based on linear matrix inequality for rotor system

Qft Robust Control Of Direct Drive Electro-Hydraulic Servo Rotary Vane Steering Gear

Position Control with Iterative Learning Method in Hydraulic System with Switch Mode Hydraulic Valve

Frequency Dependent Nonlinear Iterative Learning Control With Application To A Wafer Stage

A Practical Adaptive Sinusoidal Vibration Control Strategy for Electro-Hydraulic Shake Table