Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

Three-variable Control Technique for a Seismic Analog Shaking Table

Research On Three-Variable Control Technology Of Seismic Simulating Shaking Tables

A Novel Three-Parameter Tuning Method For Seismic Simulation Shaking Table

The Control Strategy Study for Hydraulic Shaking Table

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

Aseismic Tests of NEBS GR-63-CORE and Its Control Strategy

Three-axis vibration control based on drive spectrum modified iterative control algorithm

Research of Multi-Movement Parameters Iterative Control of Multi-Degrees-Of-Freedom Earthquake Simulation

Control strategy in earthquake simulation test based on elastic payload

Control Strategy for Multi-Exciter Random Vibration Test

Control strategy for a hydraulic shaker controlled with a 3-stage electro-hydraulic servo valve

A Two-Loop Control Method for Shaking Table Tests Combining Model Reference Adaptive Control and Three-Variable Control

Variable-parameter Feedforward Control for Centrifuge Shaking Table Based on Nonlinear Frequency Characteristic Model

Modeling and Controller Design of a Shaking Table in an Active Structural Control System

Vibration control of multiaxis hydraulic shaking table

Synchronous Tracking Control Strategy of Dual-Actuator Excited Shaking Table

Adaptive Vibration Control on Electrohydraulic Shaking Table System with an Expanded Frequency Range: Theory Analysis and Experimental Study

Influence and compensation of connection characteristics on shaking table control performance

Modeling and Vibration Decoupling Control of Multi-Axial Shaking Table

Vision-aided nonlinear control framework for shake table tests

Neural Network Based Adaptive Robust Control of a Single-Axis Hydraulic Shaking Table