Abstract:x mol% Mn-doped (Na0.85K0.15)(0.5)Bi0.5TiO3 (NKBT-Mnx, x=0, 2, 4, 6, 8, and 10) thin films were deposited on Pt(111)/Ti/SiO2/Si substrates via an aqueous sol-gel method. The effects of Mn contents on the microstructure and electrical properties of NKBT films are investigated in detail. X-ray diffraction indicates that B-site Mn substitutions do not change the perovskite structure. However, when Mn-doping concentration above 6 mol%, the impurity phase of Mn oxide exist. Raman spectra show that a new Raman mode at about 706 cm(-1) appears with Mn doping. And the gradual enhancement of this new Raman mode with increasing Mn-doping concentration confirmed the Mn substitution for B-site Ti in NKBT thin films. The ferroelectric measurement of the films indicated that, with the increase of Mn-doping concentration, the remnant polarization P-r values increased firstly with a maximum value at 6 mol% and then decreased. The optimal ferroelectric properties was obtained in the film with x=6, giving the remnant polarization (Pr) and coercive field (E-c) values of the films of 19.2 mu C/cm(2) and 106 KV/cm, respectively. According to dielectric measure, it is noted that the NKBT film with 6 mol% Mn doping exhibits the best dielectric property with dielectric constant of 492 and dielectric loss of 0.051. Owing to the reduction of transition from Ti4+ to Ti3+ and reducing the number of intrinsic oxygen vacancies, the NKBT-Mn6 shows lower leakage current density than NKBT thin film. A typical "butterfly" shape displacement-voltage loop was observed for the film samples, and piezoelectric response shows similar trend to the dielectric response with the increase of Mn-doping concentration.

Effect of V doping on phase composition and electrical properties of K0.4Na0.6Nb1−xVxO3 thin films

Phase Composition and Electrical Properties of K0.4Na0.6Nb1-xTaxO3 Lead-Free Thin Films

Effects of Na Excess on the Preparation and Characterization of (K0.5na0.5)nbo3ceramics

Effect of Nb2O5 seed layer on electrical properties of alkaline niobate based ferroelectric thin films

Improved leakage property and reduced crystallization temperature by V2O5 seed layer in K0.4Na0.6NbO3 thin films derived from chemical solution deposition

(Bi0.5na0.5)(zr0.97w0.01fe0.02)o3 Doping Effects on KNN‐based Lead‐free Ceramics Prepared Via Two‐step Sintering Technique

Effect of V2o5 Doping on the Microstructure and Local Composition of Textured Sr0.4ba0.6nb2o6 Ceramics

Dielectric and Ferroelectric Properties of (K<sub>0.5</sub>Na<sub>0.5</sub>)(Nb<sub>1−x</sub>V<sub>x</sub>)O<sub>3</sub> Ceramics

Effect of V-doping on the structure and conductivity of garnet-type Li5La3Nb2O12

Effect of Nb doping on the microstructure and electrical properties of 0.5BZT–0.5BCT thin films prepared by the sol–gel method

Structures and Electrical Properties of Mn- and Co-doped Lead-Free Ferroelectric K0.5Na0.5NbO3 Films Prepared by a Chemical Solution Deposition Method

Effects of excess amount of K and Na on properties of (K0.48Na0.52)NbO3 thin films

Effect of Amount of Polyvinylpyrrolidone Introduced in Solution-Derived Ferroelectric K0.5Na0.5NbO3Thick Films

Influence of inhomogeneous doping on chemical bond properties, microstructure, and terahertz dielectric performances of LTCC-capable ZnNb2O6 systems

Effect of Excess Ratio of Alkali Metal on Microstructure and Ferroelectric Property of K0.5Na0.5NbO3 Thin Film

Effect Of V Doping On Magnetic And Electrical Transport Properties Of La0.8sr0.2co1 (-) Xvxo3

Phase structures and electrical properties of (1-x)(K0.48Na 0.52)NbO3-x(Ba0.85Ca0.15)(Zr 0.1Ti0.9)O3 lead-free ceramics

Effect of Mn doping on microstructure and electrical properties of the (Na0.85K0.15)0.5Bi0.5TiO 3 thin films prepared by sol-gel method

Effects of Thickness on Structures and Electrical Properties of Mn-doped K0.5Na0.5NbO3 Films

Enhanced Ferroelectric Properties in Mn-doped K0.5Na0.5NbO3 Thin Films Derived from Chemical Solution Deposition

Effect of Ta-doping on Functional Properties of K0.51Na0.49NbO3