Abstract:On-orbit spectral calibration of hyperspectral imaging data is a key step for quantitatively analyzing them. Like the atmospheric correction, accurate spectral calibration is very necessary for improved studies of land or ocean surface properties. Based on the previous literatures, a new method which coupled an optimization algorithm was developed to simultaneously retrieve the central wavelength and the full width at half maximum (FWHM) of the hyperspectral sensor without needing the in situ reflectance spectra. Firstly, the Hyperion data set simulated using MODTRAN4 with the Hyperion spectral specification was used to test the new method, and the results indicated that the maximum error was less than 0.1 and 0.7 nm for central wavelength and FWHM respectively when the spectral shift is 5 nm. Then the algorithm was applied to the Hyperion data acquired on May 20, 2008 over Heihe River Basin and it was iteratively performed for each detector of the two spectrometers of Hyperion. The results showed that the VNIR of Hyperion had a pronounced smile effect, and the shift in on-orbit calibration with respect to the laboratory was from -2 to +2 nm, while the SWIR has essentially no smile effect, the wavelength correction was relatively flat over all sample with an approximately constant value of 3 nm. The FWHM in VNIR could range from -0.2 to 0.5 nm as a function of sample number of the spectrometer, and in SWIR it ranged from -2 to -3 nm. So for both the VNIR and SWIR, the original spectral calibration should be updated. These results showed good agreement with previous research findings, and which also proved the feasibility of the new method. Finally, with the updated spectral calibration characteristics, the sample reflectances of desert and vegetation target in our study site were reconstructed by applying a further atmospheric correction, and as expected, the strong spikes around the typical atmospheric absorption were almost disappeared.

Simulation study on spectral calibration of hyperspectral imagery based on target absorption features

On-Site Spectral Calibration Of Hyperspectral Imager Using Target Spectral Features

Spectral Calibratioo Of Hyperspectral Imager Based On Spectral Absorption Target

On-board Spectral Calibration Algorithm for an Airborne Hyperspectral Imager and Elimination of the Effect of the Atmospheric Underlying Surface.

Spectral Calibration of Hyperspectral Data Observed from a Hyperspectrometer Loaded on an Unmanned Aerial Vehicle Platform

Broadening the Scope of Food Quality Control: a Calibration Transfer Strategy for Minimizing External Influences on Spectral Analysis

Retrieval of Spectral Characteristics of Hyperspectral Sensor and Retrieval of Reflectance Spectra

Preflight Spectral Calibration of Airborne Shortwave Infrared Hyperspectral Imager with Water Vapor Absorption Characteristics.

In-Flight Spectral Calibration of Uav Hyperspectral Imager Based on Radiance Matching

Improved Methods for Spectral Calibration of On-Orbit Imaging Spectrometers.

Spectral Recalibration for In-Flight Broadband Sensor Using Man-Made Ground Targets.

Spectral Calibration and Accuracy Analysis Research of Pushbroom Hyperspectral Imager

Study on Calibration Method of Spatial Heterodyne Spectrometer

Spectral Calibration of the Advanced Hyperspectral Imager Aboard the Gaofen-5 02 Satellite

[Calibration of the Detection Performance for Hyperspectral Imager].

A Spectrum Extension Approach for Radiometric Calibration of the Advanced Hyperspectral Imager Aboard the Gaofen-5 Satellite

An In-Flight Radiometric Calibration Method Considering Adjacency Effects for High-Resolution Optical Sensors Over Artificial Targets

Radiometric Cross-Calibration of the ZY1-02D Hyperspectral Imager Using the GF-5 AHSI Imager

Radiometric crosscalibration of the ZY102D hyperspectral imager using the GF5 AHSI imager

Consistent Transfer Radiometric Calibration Technology for Optical Remotely Sensor and Field Campaign Validation

Review of infrared target simulator calibration system and its applications